Does a Yamaha TTR 110 have an oil filter?
I just picked up an ’11 TTR 110 yesterday so I’m no expert on them – but from the manual, there is no oil filter and it takes . 85 quarts at the oil change. Best thing to do is just use the oil dipstick to make sure you are in range.
What oil goes into a TTR 125?
I’ve taken a picture out of my manual but Yamaha recommends you put in either 10W-30 or 20W-40 type oil.
Does a TTR 125 have a air filter?
Air Filters for Yamaha TTR125 Motorcycles. Air filters are an essential component when it comes to maintaining the high-quality performance of your Yamaha TTR125. There are a wide variety of filters available for the Yamaha TTR125, which can be easily replaced.
How do you change the oil on a Yamaha TTR 125?
Press the turn bike off switch and give it a couple of kicks (to fully drain). Oil the drain bolt and screw it back in. Remove the oil filter and put the new one in.
Do you need to tighten oil filter on motorcycle?
Once it takes more than about zero effort to turn it, it only needs about 3/4 of a turn left. You really don’t want to over-tighten an oil filter. And you shouldn’t need more than a clean hand to tighten it. Don’t use a tool, unless it is attached to a torque wrench and you are tightening it to factory specs!
What to do if your oil filter is burning?
If you ride a sport bike, odds are that your oil filter will be surrounded by your exhaust headers. Since burning oil stinks, try this to keep the oil off of the hot exhaust pipes: get some aluminum foil and wrap it over the top of the headers just below the filter connection!
Where do you put the oil on a motorcycle?
Remember that on motorcycles you have to have it straight up and down, not on the side stand, to check the level. Clean it up, double check you’ve returned all the caps and bolts, and you’re good to go! Most auto places that sell you the oil will take it back if you pour it back into the original containers.