Does a Toyota 4Runner have shocks or struts?
Toyota 4Runner Suspension Shock or Strut Replacement Cost Estimate. The average cost for a Toyota 4Runner suspension shock or strut replacement is between $520 and $701. Labor costs are estimated between $196 and $248 while parts are priced between $324 and $453.
Does it matter which way you install rear shocks?
The correct way to mount it is as shown with the boot down and the label facing so it is not upside down. So, If you are not sure which way is up on your shocks or wonder if you can mount them either way, always look at the Bilstein logo.
What kind of suspension does the 4Runner have?
The rear suspension of the 4Runner uses coil springs and a solid rear axle located by five links. The FJ Cruiser used a similar arrangement, but the Tacoma looks totally different back here because it uses leaf springs.
Do rear strut bars help?
Connecting the front wheels increases understeer, and using a rear bar increases oversteer. Strut bars and sway bars are both designed to unify the suspension and improve handling, and using one doesn’t mean that you can’t use the other as well. Sway bars do a better job of reducing body roll.
Is it OK to mount shocks upside down?
No. With the exception of a few specialty shocks, you should never mount your shock absorbers upside down. Typical twin-tube shocks are simply not designed to function upside down for many important reasons.
What angle should shocks be mounted?
30 degrees is the absolute maximum and 5 degrees being ideal.
What is the shock system on a Toyota 4 Runner?
Toyota 4Runner X-REAS Shocks The Toyota 4Runner X-REAS shock system is a performance suspension option on many Toyota 4-Runner models. The X-REAS shock system, which stands for X-Relative Absorber System, is an option on all 2002 and newer 4Runners.
What does X-REAS stand for on Toyota 4 Runner?
The X-REAS shock system, which stands for X-Relative Absorber System, is an option on all 2002 and newer 4Runners.
What should I do before replacing an X-REAS shock absorber?
Make sure to prevent the tubes of these parts from bending. — Precautions for Replacing X-REAS Parts — Before removing or reinstalling a component, make sure that the front or rear shock absorber to which the component is connected is in the fully extended state.
Can a shock absorber be removed from a car?
With the shock bolt disconnected, the shock absorber and spring can be removed from the vehicle. Slide the new shock absorber and spring into position, then install the lower shock bolt. Torque to approximately 75 ft/lbs. Figure 7. Installing lower shock bolt. Slowly jack up the lower control arm to compress the suspension.