Can you remove the C clip from a raw water pump?
Remove The C-Clip Raw water pumps, while similar, all have a few features in common; a pump body, shaft, impeller, seals and either bushings or bearings. This particular pump uses two bearings that are pressed into the pump body then retained with a c-clip.
Do you need to rebuild a raw water pump?
Rebuilding is the cost effective and obvious choice provided your pump body is in good condition. This photo shows the pump shaft, the cam and the water seal. Raw water pumps, while similar, all have a few features in common; a pump body, shaft, impeller, seals and either bushings or bearings.
Is the compass marine raw water pump rebuilt?
This pump appears to have never been rebuilt and the motor has 2878 hours on her so good pumps can last a long time. This raw water pump is made by Johnson Pump as a specific OEM unit for Westerbeke. Unfortunately Johnson Pump will not sell you parts, other than an impeller, due to OEM agreements.
Where is the fresh water pump in a RV?
It is located just outside of the fresh water tank, where it pulls the water through itself and into the water main. The 12-volt water pump should be turned off when you aren’t going to be near the RV. If something goes wrong and you spring a leak, you will want to be there to limit the damage.
How to remove and install a water pump?
1. Before servicing the vehicle, refer to the Precautions section. Do not remove pressure cap with the system hot and pressurized. Serious burns from coolant can result. 2. Drain the cooling system. 3. Disconnect negative battery cable. 4. Remove upper radiator hose.
How can I check if my water pump is working?
All you need to do is connect it to your OBDII port and check for the fault codes specific to the water pump. One additional way to test if it’s actually your water pump is to use a multimeter to check that the pump itself is receiving power and has a proper ground.
How do you take the thermostat out of a water pump?
To get the thermostat out, you need to remove the two 10mm bolts that fasten the water pump to the thermostat. This is where extensions for your ratchet come in handy if you have them.
What happens to the water pump on a BMW N54?
This statement holds true for the electric water pump on the BMW N54 engine. A very common job to need to tackle on any BMW with the N54 engine is the electric water pump. This water pump usually doesn’t fail mechanically, rather it fails electronically. When this happens, it’s common to run into some obvious symptoms.