Can a motorcycle upshift into 3rd or 4th gear?
Clutch engages, shifter clicks up as normal… but bike stays in 3rd gear just revving high. Try again, no dice. 3rd time, hit the shifter REALLY hard and it goes into 4th. Ride a few miles in 4th, afraid to try 5th.
Why is my gear shift on my Harley Davidson hard?
If you are experiencing Harley neutral issues, “hard neutral”, or having a tough time shifting your Harley, you may need to address your Harley-Davidson gear shift linkage as an assembly. Sometimes, a misaligned shift linkage will be obvious to diagnose.
What’s the difference between 3rd and 4th gear?
-Riding along, great ride, up in 6th gear. Go to gas station, pull out to go back home, wide open road, shift to first, second, 3rd, now 4th… where is 4th GEAR?????? Clutch engages, shifter clicks up as normal… but bike stays in 3rd gear just revving high. Try again, no dice. 3rd time, hit the shifter REALLY hard and it goes into 4th.
What happens if your gear shift linkage is not correct?
If your shift arms are not properly aligned or your Harley-Davidson gear shift linkage is set to an incorrect length; you may experience binding, which will limit, or diminish your leverage.
What causes shifting problems in a Harley Davidson Sportster?
Shifting problems as well as noises can originate from different areas inside and outside the transmission, including the shifter, linkage, clutch, primary drive and more. Adjustments can be made that often correct shifting problems without digging into the transmission. This article applies to the Harley Davidson Sportster (1986-2016).
How to check the transmission on a Harley Davidson Sportster?
Hold the clutch lever in and place the transmission in first gear with the bike at a standstill. There should be no engine power transferring to the rear wheel. Figure 1. Sportster clutch lever and cable. The fluid level is easily checked through the derby cover or dipstick on some models.
Clutch engages, shifter clicks up as normal… but bike stays in 3rd gear just revving high. Try again, no dice. 3rd time, hit the shifter REALLY hard and it goes into 4th. Ride a few miles in 4th, afraid to try 5th.
How to shorten the linkage on a Harley Davidson Sportster?
Turn the linkage sleeve clockwise to shorten the rod and decrease the amount of lever travel required to complete a shift. If you feel a gear being selected without moving the lever, you’ve adjusted the linkage to short. Rotate the linkage sleeve counterclockwise to increase the lever travel. Tighten the jam nut once the adjustment is made.