Can a double DIN stereo fit in a Jeep Grand Cherokee?
Unfortunately, double-DIN (4″ tall) stereos won’t fit in your Jeep without modification, but you can choose nearly any single-DIN (2″ tall) receiver, thanks to a dash that’s almost seven inches deep. You’ll need a mounting kit to fill out the space around the new stereo and a wiring harness to connect the new stereo’s wires to your Jeep’s wiring.
How much does a 2002 Jeep Grand Cherokee cost?
The things I have had to deal with are: $250 blower motor control unit, $650 radiator replacement. $95 electric door and window control repair, $450 brake repair. The Jeep has 95,000 miles on it now and it runs strong. The Good 18 – 24 MPG, good traction in snow and good ride on bad roads.
Why does my Jeep Grand Cherokee make a whining noise?
If your Jeep Grand Cherokee is experiencing a whining noise, its is often going to be caused by something in the engine compartment. The likely cause of whining noise will be determined by when you hear the noise, and under what conditions
How to add a speaker to a Jeep Grand Cherokee?
Attach the new speaker to the mounting bracket, connect the wiring harness to the speaker, then plug it into the Jeep’s wiring connector. Secure the new speaker assembly to the door with the Phillips screws. Test the speaker, then reassemble the door panel.
How many miles does a 2002 Jeep Grand Cherokee have?
I have had my 2002 Jeep grand Cherokee since 2008 and it already had 67,000 miles on it. It is the straight 4.0 ltr 6. I now have 187,000 plus and it runs as great as the day I bought it.
Is the Jeep Grand Cherokee reviewed by Edmunds?
Edmunds’ expert review of the Used 2002 Jeep Grand Cherokee provides the latest look at trim-level features and specs, performance, safety, and comfort. At Edmunds we drive every car we review, performing road tests and competitor comparisons to help you find your perfect car.
How did the Jeep Grand Cherokee get its name?
There’s little doubt about the power of the Jeep name. During World War II, foreign correspondent Ernie Pyle described the U.S. Army vehicle as being “faithful as a dog, as strong as a mule and as agile as a goat.”
What kind of torque does a Jeep Grand Cherokee have?
The 4.0 L Straight Six has great low end torque to get you quick off the line and over rocks. The vehicle is body on frame which makes it very moddable so I installed a 4 inch lift to make it better offroad. Select-trac is great for offroad and snow and allows for very high traction in slippery
Unfortunately, double-DIN (4″ tall) stereos won’t fit in your Jeep without modification, but you can choose nearly any single-DIN (2″ tall) receiver, thanks to a dash that’s almost seven inches deep. You’ll need a mounting kit to fill out the space around the new stereo and a wiring harness to connect the new stereo’s wires to your Jeep’s wiring.
Attach the new speaker to the mounting bracket, connect the wiring harness to the speaker, then plug it into the Jeep’s wiring connector. Secure the new speaker assembly to the door with the Phillips screws. Test the speaker, then reassemble the door panel.
How do I add an amplifier to my Jeep stereo?
If you do not have a factory amplifier installed, then you can either interface at each rear speaker and tap into the lead there, or you can interface with the speaker output wires at the receiver (recommended). Again, refer to the link below to figure out which color wires to interface with.
When did the Jeep Grand Cherokee get a makeover?
In 1999, the Jeep Grand Cherokee underwent a complete makeover. And when we say complete, we mean it. The new and improved Grand Cherokee only used 127 parts from the previous design. The new vehicle was slightly larger overall and had a new interior layout, but it retained that classic Cherokee look and style.
Do you need an amplifier on a Jeep Cherokee?
Jeep Cherokee, Chrysler 200, and Maserati: These vehicles must be equipped with a factory amplifier as the AP4 cannot reprogram the factory radio to think that an amplifier is present. Compatible with all data-bus controlled amplified systems, no matter the screen size (including the new 12″ screen).
How do you change the stereo in a jeep?
Put the key into the driver’s door and turn it to lock, then unlock the door. This will disarm the system and make the lights stop flashing. It’s relatively easy to retain your Jeep’s steering wheel audio controls when you install a new stereo.
Put the key into the driver’s door and turn it to lock, then unlock the door. This will disarm the system and make the lights stop flashing. It’s relatively easy to retain your Jeep’s steering wheel audio controls when you install a new stereo.