Can a cooker hood be connected without a fuse?
It would be normal to have a cooker hood connected via a fused spur – or Fused Connection Unit (FCU) – to give it it’s proper name. I assume the appliance engineer confirmed there was no voltage at the cooker hood (and connected it to a different supply to test the hood itself)? In which case, you need to start checking back along the cabling.
How to fix a fuse on a fused connection unit?
Switch off the power at the consumer unit for the circuit concerned. If you have removable fuses at your consumer unit, switch off the power at the consumer unit and remove the fuse for this circuit. 2. Decide on the location of your fused connection unit making sure that you comply with current regulations.
How to rewire a fuse from an older style consumer unit?
Take the fuse wire that is of same rating as the one you just removed. 3. Insert the new fuse wire into the fuse until it pops out the other end, now wind the fuse wire on both sides around the screws making sure that it is below the washer. 4. Cut of the excess bits of the fuse wire. Make sure the connections are all tight.
Can a power supply be connected to a fused connection unit?
Fused Connection Unit. Appliances which are located in a permanent position may be connected to the power supply with a fused connection unit. Some in fact may only be connected in this way.
Where are the fuses in the under hood?
Check each of the large fuses in the under-hood fuse box by looking through the top at the wire inside. Removing these fuses requires a Phillips-head screwdriver. Check the smaller fuses in the under-hood fuse box and all the fuses in the interior fuse boxes by pulling out each fuse with the fuse puller.
What to do if your fuse box blows?
Check those fuses first, but check all the fuses before deciding that a blown fuse is the cause. Replace any blown fuses, and check if the device works. Check each of the large fuses in the under-hood fuse box by looking through the top at the wire inside. Removing these fuses requires a Phillips-head screwdriver.
Where is the fuse box in the engine?
The primary under-hood fuse box is in the engine compartment on the driver’s side. To open it, push the tabs as shown. The secondary under-hood fuse box is on the battery. To open it, push thetabsasshown.