Are there any issues with the 2008 ranger XP 700?
I just bought a 2008 Ranger xp 700 with about 120 hours on it. I’ve taken it out a few times and it has 2 issues that I’m hoping you could help me out with- 1) It didn’t idle well when I bought it but wasn’t to big of a deal at the time. Now that I’m using it I find that I would like to fix that problem but not sure how.
What’s the idle time on a Polaris Ranger 700?
That 2008 700 is a sweet machine especially with those low hours…….. It idles between 5-600 so I have to fan the throttle to keep it running. I tried the sea foam but maybe I need to do it again. I only ran half the bottle through half a tank then added more fuel half way through that tank so probably too weak?
Can a Polaris Ranger run over 30 mph?
A wider variation of topics More Popular or Trending content More relevant content to this discussion Looks good to me! 2008 Polaris Ranger 700 XP EFI – wont run over 30 MPH.
Where is the idle voltage adjustment screw on a Polaris Ranger?
If the voltage is outside of that range, turn the idle voltage adjustment screw on the left front of the throttle body (right above the throttle cable) until you have the desired voltage. Although the screw is designed to require a special tool (Polaris part # PU-47315), it can be done with needle nose pliers.
I just bought a 2008 Ranger xp 700 with about 120 hours on it. I’ve taken it out a few times and it has 2 issues that I’m hoping you could help me out with- 1) It didn’t idle well when I bought it but wasn’t to big of a deal at the time. Now that I’m using it I find that I would like to fix that problem but not sure how.
That 2008 700 is a sweet machine especially with those low hours…….. It idles between 5-600 so I have to fan the throttle to keep it running. I tried the sea foam but maybe I need to do it again. I only ran half the bottle through half a tank then added more fuel half way through that tank so probably too weak?
Why does my Polaris Ranger stall at even RPMs?
It will cut out when you give it throttle, it always is preceded with one hesitation. When acceleration is applied it staggers and farts, until you let off the throttle, then it will run fine at an even RPMs until accelerator is pushed. It will always start right up if it dies and will idle.
A wider variation of topics More Popular or Trending content More relevant content to this discussion Looks good to me! 2008 Polaris Ranger 700 XP EFI – wont run over 30 MPH.
What should the rev limiter be on a Polaris Ranger?
The wire feed to the TPS (Throttle Positioning sensor) had a chafed spot I found when I went to inspect the TPS. I placed a piece of pipe insulation between the wiring and the Starter motor’s positive connection. It cleared up! Depending on ur machine, it should have a rev limiter, but its set at like 6300 rpms or so.