Why was Landcruiser discontinued?

Why was Landcruiser discontinued?

Toyota Land Cruiser has been one of the iconic off-roaders across the world. Unfortunately, despite all its qualities, the high price of this model has been one of the factors that has played against it , causing its market share to decrease year after year.

Is Land Cruiser being discontinued?

Production has ceased on the Toyota LandCruiser 200 Series, according to Japanese reports. And with fresh reports out of Japan that Toyota will be releasing the new version of its iconic off-roader in April, the outgoing model is now almost done with.

What causes a Toyota Land Cruiser to not start?

When a starter goes bad, they will usually not give you much warning first. Also, if you are stuck somewhere and are trying to start your Land Cruiser, the old beat the starter with a hammer trick is not a wives tale. It really can get that one last start out of it. There are a lot of issues that can cause your Land Cruiser to crank, but not start.

Why does my Land Cruiser only start at 24V?

Connections on the CO relay can come loose, carbonise etc. 24v start only getting 12v will just chatter. Also check the CO relay earth that goes to the engine near the oil level float. If that’s rusty you will get a bad contact. It is a complex system and having converted mine to 12v start you have to ask if 24v is more hassle than it’s worth.

What should the voltage be on a Toyota Land Cruiser?

The voltage of the battery on your Toyota Land Cruiser can be measured precisely with a multimeter. Before the test, the multimeter is set to the voltage range of the battery and connected to its plus and minus poles. Successful testing of the car battery, i.e. checking the voltage, usually results in values ​​of approx. 12 to 13 volts.

Where is the starter on a Land Cruiser?

The relay what has probably gone sits behind the NS battery near the fuel filter. Has a posy screw holding a black protective cover on it. Under that is the relay. It has two 12mm nuts holding starter wires and two 10mm nuts.