Why is my Zanussi tumble dryer flashing red?
Start pause button flashing red with 3 beeps. The machine will run if you turn the dial and quickly press start. It then beeps regularly (5-10min?) through the cycle. If you do not press start quickly it will flash red and beep and will not start.
How do you reset a Zanussi tumble dryer?
You may be able to fix the problem by resetting the washing machine. To do this, remove the plug from the socket, wait 3 minutes and then plug it in again.
How do I remove the filter from my Zanussi dryer?
Pull the filter up….
- Open the door.
- Push the hook to open the filter.
- Use a moist hand to clean both parts of the filter.
- If necessary, clean the filter with a vacuum cleaner.
- If necessary, remove fluff from the filter socket and gasket.
How do you clear a Zanussi error code?
Step 1 Zanussi Washing Machine Fault Code Reset
- Turn the dial to off.
- Press and hold together the start button (the one with the green arrow) and the button to the left of it.
- While holding, turn the Programme Dial 1 ‘click’ clockwise(to 90 degrees temp).
How do you reset a Zanussi Lindo 1000 washer dryer?
Resetting guide: Press the two buttons at the top (soak and pre-wash). At the same time, turn the cycle selector counter-clockwise to the delicate spin cycle. Then release the two buttons and continue turning the selector counter-clockwise all the way round to off (almost one full turn).
How do you reset a Zanussi?
Resetting guide: Press the two buttons at the top (soak and pre-wash). At the same time, turn the cycle selector counter-clockwise to the delicate spin cycle. Then release the two buttons and continue turning the selector counter-clockwise all the way round to off (almost one full turn). Try to wash normally.
How does a Zanussi washer dryer work?
Zanussi’s built-in washer dryer is designed to run quietly, fit in with other appliances, and clean and dry your clothes in one go. It uses the AutoAdjust feature to weigh the load, adjusting the cycle to be as fast and efficient as possible. Giving you the most economical clean.
Why is my Zanussi tumble dryer not heating?
Cut out Thermostat faulty (TOC Thermal Overload Cut-out) Cycling Thermostat faulty. Ntc fault if fitted faulty. Air flow temperature thermostat faulty.