Why is my front end clunking after CV axle replacement?
If they run dry, or washed out with water, the needle bearing will fall apart; which results in noise and vibration in the drive shafts, and a worn out drive shaft, brass bushing and oil seal.
Can a cracked CV boot cause axle failure?
A torn or cracked CV boot will leak grease that ends up tossed around while the axle turns. A leaky boot will eventually lead to CV joint failure, as dirt and debris will get into the boot and damage the joint.
What causes a bad cv shaft assembly to fail?
A leaky boot will eventually lead to CV joint failure, as dirt and debris will get into the boot and damage the joint. Should enough grease leak out, you may notice a growling noise from a lack of lubricant, as well as a steady knocking when driving at low speeds.
When does a CV axle become loose and click?
When CV axles become excessively worn, the constant velocity joints will become loose and click when turning or accelerating. The clicks may become louder or more pronounced during sharper and faster turns and will be heard on the side with the faulty CV shaft.
If they run dry, or washed out with water, the needle bearing will fall apart; which results in noise and vibration in the drive shafts, and a worn out drive shaft, brass bushing and oil seal.
How does a CV axle work on a front wheel drive car?
A typical inner CV joint has three rollers on a tripod (spider) that can slide inside the CV joint housing, so the CV axle can extend or contract as needed. Typical CV axle (shaft) of a front wheel drive car with a Rzeppa outer CV joint and closed tripod-style inner joint. The inner CV joint can work under small angle too.
A torn or cracked CV boot will leak grease that ends up tossed around while the axle turns. A leaky boot will eventually lead to CV joint failure, as dirt and debris will get into the boot and damage the joint.
What are the symptoms of a bad CV axle?
1. Loud clicking noises when turning or accelerating. One of the most common and noticeable symptoms of a bad or failing CV axle shaft assembly is an audible clicking noise when turning or accelerating. When CV axles become excessively worn, the constant velocity joints will become loose and click when turning or accelerating.