Why is my air bag light on in my Kia optima?
If your Kia airbag light comes on, it means that the Supplemental Restraint System (SRS) has detected a problem with one of the airbags, there is a faulty airbag sensor, or the battery voltage is too low. The airbags may not deploy if you get in an accident. You need an OBD-II scanner for the airbag system.
Why is my airbag light on Kia?
The airbag light on a Kia will illuminate as “SRS,” which stands for Supplemental Restraint System. Usually it doesn’t illuminate unless the vehicle has been in an accident. If it does turn on, it means there is a malfunction with the airbag system.
Where is the reset button on a Kia airbag light?
Once you have done this, you need to reset the airbag light in order to keep the KIA’s computer functioning properly. This process will also turn off the SRS light. Find the rectangular-shaped fuse panel cover on the lower part of the driver’s side dashboard.
When to remove and reset the airbag module?
After disconnecting the positive battery cable, you should wait three minutes before removing the computer module. Once the SRS system is unplugged from the harness wiring plugs, you can safely remove and reset your airbag module.
How do you reset a Kia battery after it is disconnected?
Connect the other end of the jumper wire to the positive terminal on the battery. Enter your Kia and place the key in the ignition, turning it as far as it will go without starting the engine. Push the lock button on your key fob for three seconds, until the lights on your dashboard blink.
Why is my airbag light still on after being reset?
A scanner tool can be used to indicate the issue causing your airbag system to malfunction, and clear crash codes and hard data from the airbag computer system. After the airbag module is repaired and reinstalled, many vehicles will sense that there is no longer an issue, and the light will go off. Why is My Airbag Light Still On After Being Reset?
Connect the other end of the jumper wire to the positive terminal on the battery. Enter your Kia and place the key in the ignition, turning it as far as it will go without starting the engine. Push the lock button on your key fob for three seconds, until the lights on your dashboard blink.
How to tell if your Kia is in accessory mode?
1. Stationary with the engine running. 2. Stationary with the car in “Accessory Mode” – Start/Stop button showing Yellow. 3. Stationary with the engine stopped & the Start/Stop button showing Green.
How do you turn off the engine on a Kia?
Open the cover on the diagnostics port and connect a jumper wire to the connector inside the port marked “6.” Connect the other end of the jumper wire to the positive terminal on the battery. Enter your Kia and place the key in the ignition, turning it as far as it will go without starting the engine.