Why is my abs light on on my Harley Davidson touring bike?
Some Touring bikes even had a factory recall due to a rear brake light switch that was failing, and could leak, so be sure to check there. If you have a leak and are losing brake fluid, that may be the reason your ABS light is staying on. Figure 3. Rear brakes have a pressure switch plumbed into the brake hose.
When does your abs light go on and off?
Before we go further, though, here’s a simple reminder. It is normal for your ABS light to light up when you first start your bike. However, after you start moving at about 10 mph, your ABS light should go off. If it is staying on at the point or later, let’s check a few things.
Where is the brake light on a Harley Davidson?
The problem is usually found in the right handlebar switch housing where the front brake switch is located. Actuation of the switch is accomplished by the interplay between the brake lever/master cylinder assembly and the light switch.
Why is my rear brake light not working?
The rear brake light switch has proven quite problematic as well, and even forced Harley at one point to issue a recall on Touring models for it failing. The rear switch is hydraulic pressure-operated and, being close to the exhaust system, can fail in a variety of ways.
Some Touring bikes even had a factory recall due to a rear brake light switch that was failing, and could leak, so be sure to check there. If you have a leak and are losing brake fluid, that may be the reason your ABS light is staying on. Figure 3. Rear brakes have a pressure switch plumbed into the brake hose.
Before we go further, though, here’s a simple reminder. It is normal for your ABS light to light up when you first start your bike. However, after you start moving at about 10 mph, your ABS light should go off. If it is staying on at the point or later, let’s check a few things.
The problem is usually found in the right handlebar switch housing where the front brake switch is located. Actuation of the switch is accomplished by the interplay between the brake lever/master cylinder assembly and the light switch.
The rear brake light switch has proven quite problematic as well, and even forced Harley at one point to issue a recall on Touring models for it failing. The rear switch is hydraulic pressure-operated and, being close to the exhaust system, can fail in a variety of ways.
What should I do if my abs light comes on while driving?
If the ABS light turns on while you are driving, it is recommended that you first check the tires and the brake fluid level. If they turn out fine, you should consider consulting a mechanic for a scan of your module. Remember to drive and brake slowly on your way, as you cannot be sure that the car is operating at its optimum.
What kind of bike has a flashing ABS light?
Good morning I ride a 2008 Ultra, getting ready for a 5 day ride, leaving shortly. I checked the bike over, started the bike, the ABS light is flashing & will not cancel.
What causes the ABS light to go off without scan tool?
The following steps will help you reset the ABS light without using any scanning tool. The illuminated ABS light might be caused by the emergency brake’s failure to go down far enough to be applied. Adjust the emergency brake into the proper down position to make the light go off. Only use quality brake fluids from trusted manufacturers.
When did my 2009 Road King Classic ABS unit fail?
2009 Road King Classic, abs unit failed in second year, I don’t trust my dealer here in Houston, They left a battery wire off my led lights which caused them to acquire a ground through the engine light system.
Are there any other vehicles that use ABS?
There are countless vehicles on the road, other than Harley Davidson, that utilize ABS systems and Dot 4 brake fluid. It is unsettling to us why Harley Davidson is, seemingly, the only vehicle manufacturer failing in this area.