Why does my Jeep Cherokee have a service transmission light?
Bought my Trail Hawk used with only 18,000 k on it. Thought it was a great deal. Noticed right away that the transmission jerked especially when in low gears. Then one day the service transmission light came on and the engine light. The car lost power and felt like it was in neutral.
How to check engine light codes on Jeep Cherokee?
Jeep Check Engine Light Codes 1 Connect scan tool to the 16-pin data link connector (DLC) located near the steering column. The connector may have a removable cover. 2 Turn the ignition on. 3 Follow scan tool manufacturer’s operating instructions to access the Diagnostic Trouble Codes (DTC’s).
What was the transmission message on my 2016 Jeep Cherokee?
My 2016 Jeep Cherokee started having issues on my way home from work yesterday, the service transmission message popped up on my display and the engine light came on. The service transmission was on for approximately 5 minutes, and during this time it felt like the car wouldn’t accelerate.
Why does my check engine light keep coming on?
A failing oxygen sensor, also known as an O2 sensor, is one of the most common reasons for that Jeep check engine light to come on. And the tricky thing with the O2 sensor is that the car will continue to drive well so you might want to dismiss the light. But an O2 sensor code will surely show up in a diagnostic test.
Jeep Check Engine Light Codes 1 Connect scan tool to the 16-pin data link connector (DLC) located near the steering column. The connector may have a removable cover. 2 Turn the ignition on. 3 Follow scan tool manufacturer’s operating instructions to access the Diagnostic Trouble Codes (DTC’s).
Bought my Trail Hawk used with only 18,000 k on it. Thought it was a great deal. Noticed right away that the transmission jerked especially when in low gears. Then one day the service transmission light came on and the engine light. The car lost power and felt like it was in neutral.
My 2016 Jeep Cherokee started having issues on my way home from work yesterday, the service transmission message popped up on my display and the engine light came on. The service transmission was on for approximately 5 minutes, and during this time it felt like the car wouldn’t accelerate.
A failing oxygen sensor, also known as an O2 sensor, is one of the most common reasons for that Jeep check engine light to come on. And the tricky thing with the O2 sensor is that the car will continue to drive well so you might want to dismiss the light. But an O2 sensor code will surely show up in a diagnostic test.
Are there any problems with the Automatic Transmission Control Module?
Jeep Wrangler owners have reported 30 problems related to automatic transmission control module (under the power train category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Jeep Wrangler based on all problems reported for the Wrangler.
What is the transmission temp sensor on a Jeep Wrangler?
P0714 transmission temp sensor intermittent. P0613 internal tcm problem. Instrument cluster: 1 tcm/single board engine control message not received data list for tcm is reading 1023 degrees fahrenheit or 1. 10 volts having code p0613 tcm is faulty. ## #vpic# 1 – check digit (9th position) does not calculate properly #vpic#.
Why is my transmission not working on my Jeep Wrangler?
Instead, the engine revs to 4k, and it will stay in the gear. Only if I let off the gas and allow it to reset, then gradually accelerate will it work properly. The dealership and Jeep have not been able to figure out the issue, having replaced the entire transmission, pcm, and ecu, as well as numerous other parts and sensors.
https://www.youtube.com/watch?v=pEGtj3tjDwk