Why did my moped stop running?
The most common reasons are carburetor issues such as a vacuum leak, fuel leak, or tuning issues. Other culprits could include corroded or cracked spark plugs or spark plug wires, a faulty ignition coil, a clogged air filter, or engine timing issues.
How do I get my scooter to run?
Press the ignition and see if the engine turns over. After sitting for a while, you may need to crank it for a few seconds to circulate oil. If the scooter starts and the engine is running smoothly, you should be good to go!
What can I do about a Kymco scooter that won’t keep running?
I have a brand new 2011 PGO ligero (genuine buddy) 50cc that is cutting out, lurching, coughing and sputtering once it gets into the higher gears. It is … What can I do about a Kymco scooter that won’t keep running?
Why is my Kymco still running even with the ignition switch off?
Something has to be draining your battery. Try to find out what is still pulling power. What could still be running even when your ignition switch is off. Usually it’s the parking light. Depending on your make the last turn of your key after your lock, is a parking light notch.
Why does my mobility scooter stop after a mile?
It is fully charged but stops completely after a mile, I need to charge it again to clear the flashing fault indicator but then after a mile or so back to square one. It appears that because there is no green light showing, there may be a problem with the motor or a wire that has become disconnected somewhere.
Why is my Kymco motor drawing too much current?
Whichever plug it is it shouldn’t be getting hot – heat is an indication of excess current flow or a poor contact. I suggest you add more information in the comments. Kymco… • Answered on Jan 02, 2021 Check the motor for a dirty commutator. This will make the motor draw too much current.
What are the problems with a Kymco bike?
1. Low coolant level. 2. Restricted radiator airflow. 3. Faulty thermostat. 4. Coolant pump or fans inoperative. 5. Vent hose crimped. 6. The air in the coolant and needs bleeding. 7. Engine idling too long or bike moving too slow. 8. Coolant too old needs to be replaced. 9. Faulty temperature sensor, wiring or connector. 10.
What’s the best way to fix a Kymco?
Kymco… • Answered on Jan 02, 2021 Check the motor for a dirty commutator. This will make the motor draw too much current. Kymco… • Answered on Jan 01, 2021 Usually related to needing service or battery state. Remove the battery terminals and clean the battery posts and the connector on the wire. Fully charge the battery.
Whichever plug it is it shouldn’t be getting hot – heat is an indication of excess current flow or a poor contact. I suggest you add more information in the comments. Kymco… • Answered on Jan 02, 2021 Check the motor for a dirty commutator. This will make the motor draw too much current.
Why does my mobility scooter keep stopping and starting?
Sometimes a user can experience a problem where the mobility scooter keeps starting and stopping, what may happen is that it may travel a few meters and then stops and then allows you to move a little further and then stops again.