Where is the power window located on a Toyota 4Runner?
All of your power windows operate through one large fuse block called the integration relay. It is located on the back of the fuse box behind the driver’s side kick panel. The relay is connected to a fuse. Although, you might want to check the fuse first. Set your multimeter to ohms and touch the probes to the opposing prongs on the fuse.
Where is the integration relay on a Toyota 4Runner?
All of your power windows operate through one large fuse block called the integration relay. It is located on the back of the fuse box behind the driver’s side kick panel. The relay is connected to a fuse. Although, you might want to check the fuse first.
How do you change the fuse on a Toyota 4Runner?
Set your multimeter to ohms and touch the probes to the opposing prongs on the fuse. If the meter doesn’t change, then the fuse needs to be replaced. If the meter shows less than one ohm, then the fuse is still good. Below the fuse box you should see the integration relay.
How to reset the driver’s side power window?
To reset the driver’s side power window auto-close: 1. Push down and hold the driver’s door power window switch to completely open the window. 2. Pull and hold up the driver’s door power window switch until the window closes.
Why does my drivers side window not work?
A smaller version of GM’s rebirth of the Hummer. Hard to start yesterday,drivers side window,power door locks wont work,either by buttons on both doors or on key fob.Other windows work! Replaced Battery checked door lock fuse,still no drivers side window or door locks. Answered! View the answer I have this problem too Is this a good question?
How do you roll down the window in a Toyota?
1. Turn ignition switch to the “ON” position. 2. Push the back door power window switch to the “DOWN” side to open the window. 3. Push and hold the back door power window switch to the “UP” side until the window closes. Continue holding it for approximately 1 second.
Why is the power window on my car not working?
The problem lies in the window regulator. If you’re seeing the toggling voltage, the problem is in the window regulator. It’s either a bad motor or a broken regulator that’s causing the motor to stall. Reconnect the electrical connector to the motor and try operating the window.