Where is the passenger airbag module located?
In most cars it is under the center console that is between the two front seats, or center of the dash on the floor. In most GM cars it is under the driver or passenger seat.
Is the Nissan Frontier air bag control module genuine?
We offer a full selection of genuine Nissan Frontier Air Bag Control Modules, engineered specifically to restore factory performance. Please narrow the SRS Airbag Module results by selecting the vehicle.
Where is the SRS airbag control module located?
In most GM cars it is under the driver or passenger seat. Disconnect the positive battery cable and wait 3 min. You are now safe to unplug the airbag control module harness wiring plugs. All airbag srs components must be installed and connected properly before installing the airbag control module.
Can a Nissan airbag module be reset by myairbags?
The best part of having your Nissan’s original airbag module reset by MyAirbags is that when you get your airbag control module back and it goes back into the same vehicle that it came out of then it will be plug-n-play. No additional programming of the VIN is required.
How do you install an airbag control module?
All airbag srs components must be installed and connected properly before installing the airbag control module. This includes air bags, seat belts, clock spring and impact sensors. Disconnect the battery and bolt down the module and then connect the harness wiring plugs.
We offer a full selection of genuine Nissan Frontier Air Bag Control Modules, engineered specifically to restore factory performance. Please narrow the SRS Airbag Module results by selecting the vehicle.
How to contact Nissan air bag module reset?
Call us at 888-779-9029 M-F 9-5 EST Frontal collision detected. Driver and/or front passenger air bag modules are deployed Side collision detected. Curtain air module and seat belt pre-tensioner are deployed Seat belt buckle switch LH circuit is shorted to ground.
All airbag srs components must be installed and connected properly before installing the airbag control module. This includes air bags, seat belts, clock spring and impact sensors. Disconnect the battery and bolt down the module and then connect the harness wiring plugs.
In most GM cars it is under the driver or passenger seat. Disconnect the positive battery cable and wait 3 min. You are now safe to unplug the airbag control module harness wiring plugs. All airbag srs components must be installed and connected properly before installing the airbag control module.