Where is the ignition switch on a GM PassLock?
Pull the radio out of it’s cavity. Disconnect the wiring connector and the antenna wire, and set the radio aside. On the left side of the radio cavity, there will be an opening, through which you will be able to see the Ignition Switch.
How to bypass the PassLock sensor on a 2002 Pontiac Grand Am?
This web page will guide you through the steps necessary to bypass the “Passlock Sensor” on a 2002 Pontiac Grand Am, and keep the “SECURITY” light off forever. The steps necessary are similar on the other models listed above. There are generally only minor differences in how to get the radio out to get to the wires.
What are the three wires in a GM ignition switch?
In GM cars, there is a bundle of three wires which go from the Body Control Module to the Ignition Switch. They are Black (analog return), White (power), and Yellow (analog data).
How to make a link GM passkey no start bypass?
HERE IS THE LINK GM Passkey NO start Bypass Cut two terminals off the end of the terminal strip. Set the rest of the terminal strip aside. Takle one of the 2200 ohm resistors and bend the leads as I’m doing here. Then cut off the excess lead wire. (The color code for the resistor is three red bands.)
Pull the radio out of it’s cavity. Disconnect the wiring connector and the antenna wire, and set the radio aside. On the left side of the radio cavity, there will be an opening, through which you will be able to see the Ignition Switch.
What to do if your PassLock light does not turn on?
Insert the Key into the ignition switch and try to start the car. It should start, and then stall, with the “SECURITY” light flashing. (In rare cases, the car may keep running and the security light will not illuminate, but that only happens if you are very lucky.)
In GM cars, there is a bundle of three wires which go from the Body Control Module to the Ignition Switch. They are Black (analog return), White (power), and Yellow (analog data).
Why does my steering wheel lock when I Turn Off the engine?
If you turn off the engine with the steering wheel turned or turn the steering wheel after turning off the engine, the steering wheel lock can bind and prevent you from turning the ignition. How To Fix It: Fortunately, this is an easy fix. Just turn the wheel back and forth until the ignition cylinder is freed.
Can a unworn key turn an ignition cylinder?
Or, an unworn key may not turn a worn ignition cylinder, as they haven’t “worn together.” How To Fix It: The best way to do this is to get a new lockset, with new keys and a new cylinder. You might consider getting a matched lockset that includes the door and trunk cylinders.
Insert the Key into the ignition switch and try to start the car. It should start, and then stall, with the “SECURITY” light flashing. (In rare cases, the car may keep running and the security light will not illuminate, but that only happens if you are very lucky.)