Where is the high side port?
The high-pressure service gauge port valve is located on a vertical extension off the receiver/drier tank. The valve can be accessed through an access hole in the upper radiator air deflector to the right of the LH headlamp.
How do I add Freon to my car?
To fill the system with refrigerant:
- Squeeze the trigger for 5-10 seconds, slowly tipping and shaking the can.
- Wait 30 seconds for the pressure to equalize.
- Read the pressure displayed on the gauge again.
- When the pressure is correct, stop filing the system and wait a few minutes.
What is the high side AC port for?
The high side service port is a fitting that provides access to the high pressure side of the AC system and the low side service port is a fitting that provides access to the low pressure side of the AC system.
How much refrigerant does a Toyota air conditioner hold?
Most midsize cars made since 2000 will hold between 28 and 32 oz. of refrigerant; however, larger vehicles and those with rear air conditioning controls typically hold more refrigerant. Remember that you will most likely have some refrigerant left in your Toyota, so you will not be required to install the full capacity of refrigerant every time.
Where is the low side service port on AC Avalanche?
To summarize: Every A/C System has two service ports: A high side and a low side. When recharging with AC Avalanche, you will only use the low side service port. The low side line of the system will have a larger diameter metal pipe than the high-side. The low side service port is usually located between the AC compressor and evaporator.
Where is the low pressure air conditioner port?
The first step in recharging your system is to locate the low side service port (or low-pressure port). Every auto air conditioning system has two service ports: one on the high pressure and one on the low pressure side. When recharging with AC Avalanche refrigerant, for safety, you will
Where is the AC compressor on a Toyota?
Look for the single wire connector on the compressor’s front side and connect it to a jumper wire. Attach the jumper wire to the Toyota’s positive battery terminal. The compressor should turn on.