Where is the code on a Honda CBR 600RR?
The plug is under the seat, right side of the bike, near the ECM , at the right rear of the battery. There are 2 wires to the plug, and you need to jump them, then turn the key “on”, with the kill switch on “run”. If there’s a code, the FI will flash your code (s). Count the flashes.
What is the Mil light on a CBR 600 RR?
I’m on a CBR 600 RR 2004, just thought I’d get that straight first of all. The malfunction indicator light (MIL) comes on intermittently, along with the FI indicator on the Multi Function Display.
Is there an error code flashing on my na bike?
No, That is not the error Code Flashing… unless the way to pull teh codes is different on a UK bike than a NA bike. You Need to Jump a Plug under the seat and then it will flash the code at you. Also there are a few places on the web that you can download service manual and that will explain testing/trouble shooting & codes.
What is the fault code for CBR 1100 Blackbird?
I found a diagnostics list on another forum (for CBR 1100 Blackbird) at the time I didn’t know it was for a different CBR. that stated that the fault code was 23 and it was the oxygen sensor heat element that was faulty. I tested both O2 sensors with a multimeter and the both read 32 ohms of resistance, suggestion either no fault or both faulty. 1.
What’s the failure code for a Honda CBR 600 F4i?
Connection: Yellow/Red (+) – Ground {-) Standard: 4.75-5.25 V Turn the ignition switch to “OFF”. Disconnect the MAP sensor 3P connector. Turn the ignition switch to “ON”. Measure the voltage at the wire harness side connector. Open or short circuit in Yellow/Red wire. Loose or poor contact on the ECM connectors.
What does PGM-FI Mil stand for on Honda CBR 600?
• The PGM-FI MIL denotes the failure codes (the number of blinks from 0 to 33). When the indicator lights for 1.3 seconds it is equivalent to 10 blinks For example, a 1.3 second illumination and two blinks (0.5 second X 2) of the indicator equals 12 blinks.
When to use code 12 on Honda CBR 600?
When the indicator lights for 1.3 seconds it is equivalent to 10 blinks For example, a 1.3 second illumination and two blinks (0.5 second X 2) of the indicator equals 12 blinks. Follow code 12 on page 5-26. • When more than one failure occurs, the MIL shows the blinks in the order of lowest number to highest number.