Where can I buy a multi function steering wheel?
Available options include: Multi-Function Steering Wheel from Audi A4, A3, or A6 + matching airbag eBay is a good source for steering wheels or www.airbagsforsale.com I was able to purchase the steering wheel and airbag with correct harness for ~$649 shipped. Control Module – 8E0-953-549-R www.autopartsnationwide.com $209.49
How do you remove airbag from steering wheel?
Disconnect the battery using the 10mm wrench. Begin by adjusting the steering wheel to it’s lowest and nearest position (pulled toward you). Turn the steering wheel to gain access to the two screws on the rear of the steering wheel which hold down the airbag. Once the airbag is loose, unplug the connector from the back of the airbag.
What are the wires in the steering column?
not present Letter W Wire Color F Function G G B Black H Horn Relay H H L Light Blue L Left Front Turn Signal J J B Blue R Right Front Turn Signal K K B Brown H Hazard Power (+12V) L
How do you remove steering column cover on Audi A4?
Locate the screw under the steering column cover and remove using the Allen Hex 4mm. Pull apart the top and bottom of the covers. Using a small flat screwdriver, unclip the three plastic tabs holding the SC ring in place. These are the only things holding the SC ring in place.
How to install a multi function steering wheel?
Fit the sports steering wheel (1) and tighten the screws (2) with a torque of 63 Nm. Connect the plug (3) to the switch mounting. Install the existing airbag unit (1). Fit the existing 4-spoke steering wheel (1) and tighten the screws (2) with a torque of 63 Nm. Install the airbag unit with the multi-functional steering wheel buttons (1).
How do you connect a steering wheel to a cruise control unit?
Place the connection cable (1) from the installation kit into the cable tie (2). Place the cover cap (1) and switch unit on to the steering wheel. Connect the connection cable (2) to the switch unit. Secure the cover cap (1) to the steering wheel using Torx bolts (3).
How do you connect a switch to a steering wheel?
Insert the switch unit (1) and secure it with Torx bolts (2). Place the connection cable (1) from the installation kit into the cable tie (2). Place the cover cap (1) and switch unit on to the steering wheel. Connect the connection cable (2) to the switch unit. Secure the cover cap (1) to the steering wheel using Torx bolts (3).