Where are the spark plugs on a Mitsubishi Lancer?
*Ground to engine block, which is connected to the battery-ground. *One near the air con relays above the FR wheel arch in the engine bay. *Rear light harness – body ground, Behind the Rear left panel in boot. The engine ran beautifully for a month. Then BAM, the misfire came back. I checked the spark plugs, coil packs & leads. They all passed.
What kind of misfire does a 2000 CE Lancer have?
2000 CE Lancer GLXi 1.8 4g93, Misfire, Ignition, Grounding This post is mostly to help lancer owners with their 2000 CE Lancer 1.8 4G93 engine, and how to diagnose a ignition misfire. I state that I’m a back yard mechanic with no mechanical qualifications, but I have tons of backyard/hands on experience.
Are there any problems with the Mitsubishi Lancer?
If you’re to scared, rich or have no interest in doing it yourself, stop reading and take the vehicle to your local mechanic. For the rest of you that have the same or similar problems I had, lets continue. There are different models and drives for the lancer which was released. So the engine configuration might be different on yours.
What happens when an ignition coil goes bad on a Mitsubishi?
When one or several ignition coils on your Mitsubishi (or Chrysler Sebring or Dodge Stratus) have gone BAD, you’ll know right away. Your vehicle will display one of the following symptoms: The car will run and idle rough. No power as you accelerate the car down the road.
When one or several ignition coils on your Mitsubishi (or Chrysler Sebring or Dodge Stratus) have gone BAD, you’ll know right away. Your vehicle will display one of the following symptoms: The car will run and idle rough. No power as you accelerate the car down the road.
What causes a cylinder to misfire on the ignition coil?
CASE 3: Cylinder #2 is NOT getting spark. This lack of spark will cause a cylinder misfire. You can conclude that the ignition coil is bad if the spark plug wire of cylinder #3 is firing spark. You can conclude this because cylinder #2 and cylinder #3 receive spark from the same ignition coil.
What happens when ignition coil does not spark?
CASE 2: The multimeter DID NOT register 10-12 Volts (or the test light DID NOT light up). The ignition coil will not fire off spark if it’s missing these 10 to 12 Volts. The next step is to repair the cause of these missing 10 to 12 Volts. The ignition coil will spark again once this voltage is restored to it.
Do you need scan tool for Mitsubishi ignition coil?
Testing the Coil-On-Plug (COP) ignition coils on your Mitsubishi vehicle (or Chrysler Sebring or Dodge Stratus) doesn’t require any expensive testing equipment or expensive tools. As mentioned at the beginning of the article, you don’t need a scan tool.