Where are the ABS sensors located?
wheel hub/rotor
Where are these sensors located? The ABS sensor is typically located in each wheel hub/rotor on a four channel ABS system. Some rear wheel drive applications have the sensor mounted in the rear differential.
Where is the ABS sensor fuse located?
engine compartment
The fuse box for the ABS is located in the engine compartment on the passenger’s side.
Where is the ABS brake module?
The ABS control module is found in the engine compartment of most vehicles. However, it can also be found on the driver’s side frame rail in a few models. You may need to lift the vehicle to find the ABS control module. It could also be located under plastic panels or covers.
What causes ABS sensor to fail?
What are the common causes of failure? Typically these sensors will fail as a result of clogging from metallic debris, brake dust or dirt due to exposure to the harsh elements.
Can I pull ABS fuse?
Remove the anti-lock brake fuse or relay that needs to be replaced. This is typically done by pinching them between your fingers and pulling them up and out or by using the fuse removal tool supplied by some manufacturers.
How to bleed base brake on Ford ABS?
1 Perform base brake bleeding. 2 Connect scan tool to the Data Link Connector (DLC). 3 Select ANTI-LOCK BRAKES, followed by MISCELLANEOUS, then ABS BRAKES. 4 Perform base brake bleeding a second time.
How is the ABS light different from the brake light?
The ABS light differs from the BRAKE light as it is usually controlled by a computer module. When this light is on, there are often trouble codes stored to help the owner or a technician diagnose the source of the fault in the anti-lock braking system. The BRAKE light on most vehicles is activated by…
What happens when you unplug an ABS sensor?
If unplugging the sensor makes your problem go away, don’t be fooled. You’ve simply disabled the entire ABS, masking the symptoms. The sensor can be checked for proper function without replacing it.
How can I check the ABS on my car?
Depending on the year of the vehicle, most ABS codes can be read by OBDII-based diagnostic tools on ‘96+ vehicles. On older vehicles or in special cases, a make-specific tool must be used, often owned by dealerships or independent shops.