When to replace the battery on a Pontiac Montana?
Easy guide to replacing the battery on Pontiac Montana model years 2002 – 2008. After changing the battery the battery light no longer comes on and it also no longer says charging system failure on the dashboard. My mechanic says he does not believe it is the starter and doesn’t want to replace it until it goes all the way out. (LOL).
What are common reasons my Pontiac Montana won’t start?
What are common reasons my Pontiac Montana won’t start? While there are a variety of reasons your Pontiac Montana won’t start, the most common 3 are a dead battery, an alternator problem, or failed starter. How is a no-start diagnosis fixed?
Can a battery be removed from a 2005 Chevy Van?
Removing the battery from a 2005 Chevy Venture van, whether for servicing or replacement, is a fairly common procedure that can be done by the van’s owner. Park your 2005 Chevy Venture van in a spot that gives you room to work around the engine compartment. Shift the van into park and set the parking brake.
Where is the battery brace on a 2005 Chevy Venture?
Loosen the battery brace holding the battery in place. The bolt for this is located at the base of the battery mounting plate. Unscrew the bolt with the adjustable wrench and remove the brace. Remove the battery from the 2005 Chevy Venture van.
Can you replace a car battery at a dealership?
Never ever ever buy a battery at a dealership, what a ripoff, $280?! Same problem. was time to replace battery, have 2013 Chev Silverado, only 56 000 km, however upon replacing battery, vehicle will not start. Purchased battery at GM Dealership, cannot boost, any suggestions please, thank you.
What’s the warranty on a car battery that stops working?
First of all, even the cheapest car battery should have at least a 1-year warranty which will likely cover instances where it simply stops functioning without any apparent reason. So your investment will be covered in this case.
Why does my car not start after I replace the battery?
Evaluating Your Car’s Key Systems for Possible Failure. There are many other possible problems that could lead to the fact that, after you’ve replaced the battery, the car won’t start. One or more of several key systems might not run properly, or there could be a serious malfunction with the electrical system.
Easy guide to replacing the battery on Pontiac Montana model years 2002 – 2008. After changing the battery the battery light no longer comes on and it also no longer says charging system failure on the dashboard. My mechanic says he does not believe it is the starter and doesn’t want to replace it until it goes all the way out. (LOL).
What to do when left side light goes out on Pontiac Montana?
Use a small flat blade screw driver to clean the pin connection on the PC Board side. Go to the junk yard and cut out a couple of these wire harnesses for the plug. Cut off about 6″ of wire with the plug. Use a wire crimp tool to replace the plug. Be sure to wire it exactly as the one you remove. If you forget how, look at the left side light.
Where does the motor go on a Pontiac Montana?
The motor has two male prongs…the down-motion male prong goes into the brown wire side of the female plug connector, the up-motion male prong goes into the blue wire side of the female plug connector. The motor sits in a plastic plug that does not have a ground.
What to do if your Pontiac Montana is corroded?
Look at the connector end. The connector is melted around that plug location and the connector is also black and corroded. Use a small flat blade screw driver to clean the pin connection on the PC Board side. Go to the junk yard and cut out a couple of these wire harnesses for the plug. Cut off about 6″ of wire with the plug.