When to change timing belt on Mitsubishi Magna?
Magna belts are generally pretty durable, but the recommended change time is 100,000 km. Disclaimer: You acknowledge and agree that all answers are provided as a general guide only and should not be relied upon as bespoke advice.
How to change the pulley belt on a Magna?
Remove the A/C compressor drive belt from the pulleys. Properly route and install the A/C compressor drive belt on the A/C compressor, the power steering (if equipped), and the crankshaft pulleys. Adjust the A/C compressor drive belt to obtain 6-9 mm (0.24-0.35 in) deflection.
When did the first Mitsubishi Magna come out?
The model debuted in 1987. Initially Magna was equipped with in-line four-cylinder engines and bodies sedan and station wagon. Over the years, each new series increased in size, and with the second generation in 1991, the range was supplemented by a luxury version called Mitsubishi Verada with a V6 engine.
Where was the Mitsubishi Verada and Magna made?
Mitsubishi Motors Australia Limited produced Mitsubishi Verada and Mitsubishi Magna at its Clovelli Park plant in South Australia. Most engines – primarily the original four-cylinder Astron II (model 4G54) and subsequent V6 engines (model 6G72 and 6G74) -were manufactured in Lonsdale, South Australia.
Magna belts are generally pretty durable, but the recommended change time is 100,000 km. Disclaimer: You acknowledge and agree that all answers are provided as a general guide only and should not be relied upon as bespoke advice.
Remove the A/C compressor drive belt from the pulleys. Properly route and install the A/C compressor drive belt on the A/C compressor, the power steering (if equipped), and the crankshaft pulleys. Adjust the A/C compressor drive belt to obtain 6-9 mm (0.24-0.35 in) deflection.
What kind of car is 1997 Mitsubishi Magna V6?
I have a 1997 Mitsubishi Magna V6 THE Executive that in the last couple of days has been losing power on acceleration. We use cookies to give you the best possible experience on our website. By continuing to use this site you consent to the use of cookies on your device as described in our cookie policy unless you have disabled them.
How big should the hydraulic tensioner be on a Mitsubishi Magna?
Rotate the engine two full rotations and then inspect the piston of the hydraulic tensioner. It should be extended -no more than 5mm-. Realistically, about 3-4mm is where you want to be. If the piston is extended more than 5mm, the mechanical tensioner was too lose.