When to build a mock up bridge girder?
When required to complete a mock-up bridge girder, the fabricator shall create a general note sheet, girder detail, and shop assembly drawings and then build a mock–up bridge girder. Shop and assembly drawings shall be prepared and submitted to for the documentation audit prior to the scheduling of an on-site audit.
How to fit fillet to a bridge girder?
None Mill to bear fitting Fillet welding (Stiffeners) The stiffeners shall not be welded prior to the on-site audit. Use SAW or FCAW to weld the stiffeners. The fit up, tacking and welding of the stiffeners shall be witnessed by on-site auditor. Match marking (Splice plates) Fabricate splice plates for a flange.
How big of a field Splice do I need for a girder?
have a mill to bear condition at the bottom flange. All stiffener welding shall be 1/4 inch minimum fillet weld. 3.11 At the end of the girder opposite the welded field splice preparation, a bolted field splice shall be prepared for either the top or bottom flange with a minimum of 12 holes in the flange for 7/8 inch diameter, ASTM A325 bolts.
When required to complete a mock-up bridge girder, the fabricator shall create a general note sheet, girder detail, and shop assembly drawings and then build a mock–up bridge girder. Shop and assembly drawings shall be prepared and submitted to for the documentation audit prior to the scheduling of an on-site audit.
None Mill to bear fitting Fillet welding (Stiffeners) The stiffeners shall not be welded prior to the on-site audit. Use SAW or FCAW to weld the stiffeners. The fit up, tacking and welding of the stiffeners shall be witnessed by on-site auditor. Match marking (Splice plates) Fabricate splice plates for a flange.
have a mill to bear condition at the bottom flange. All stiffener welding shall be 1/4 inch minimum fillet weld. 3.11 At the end of the girder opposite the welded field splice preparation, a bolted field splice shall be prepared for either the top or bottom flange with a minimum of 12 holes in the flange for 7/8 inch diameter, ASTM A325 bolts.
How do you adjust the handlebar on a Pedego?
Insert the handlebar stem into the frame of the bicycle. You may adjust the height of the handlebar by moving the stem up or down to your comfort level. Place your thumb on the locking mechanism on the left side of the stem, depress the button and lift the lever up exposing the adjustment screws (Figure 1).