When does a Mercedes slk230 K40 fail to restart?
First, the customer complaint: car runs great, no problems, but it will occasionally die and fail to restart. About 15-20 minutes later, it will usually start and all is well until it does it again. Vehicle usually has to be driven 20 minutes or so before failure will occur.
What does it mean when your turn signal is not working on Mercedes?
In newer Mercedes models, you will get a warning on instrument cluster stating “Turn Signal Left / Right / Front / Rear / Side Malfunction”. Depending on the Mercedes model and problem a warning may or may not show on the dashboard.
Are there any problems with the Mercedes transmission?
Including Engine, Transmission, ABS, Airbag, SRS, SBC Brakes, ESP, EPS, Air Suspension and more. In depth troubleshooting, but only works on MB cars. 2. Launch Creader X431 VII works in European, Asian and Domestic Cars.
Can a Mercedes slk230 be a good roadster?
Side note: if you’re 6’3″ or so, the Mercedes SLK230 may not be your best roadster option. Failure occurred just as the customer described, and the yellow traction control light in the middle of the speedometer was constantly on during cranking attempt (above), and the starter would not crank. Google to the rescue!
Can a Mercedes-Benz have a transmission failure?
Very few Mercedes-Benz cars have had complete transmission failure and require transmission replacement. We see these transmission fail in rare cases when water enters the transmission via the oil cooling lines or the radiator on cars equipped with Valeo radiators.
Why are the turn signals not blinking on my slk230-97?
It is a feat of plastic mechanical engineering and contains a folded flexible circuit board that would win any origami prize! I have the same problem with my SLK230 -97, the turn signals stays on instead of blinking. since they stay on it cant be a dry (i.e. bad) solder joint.
Why are the flashers on my Mercedes not working?
I had the same problem with the flashers intermittently not working. I eventually traced it to a dry (i.e. bad) solder joint on one of the legs of the fuse holder for the flasher circuit. This is in the light switch/fuse module in the console next to the steering wheel (accessible when you open the driver’s door).
What are the problems with a Mercedes Benz?
Top 5 Mercedes-Benz no start problems 1 Engine Click, No Start 2 Engine Dies Right After It Starts 3 Car turns over, but it won’t start 4 The car makes a clicking noise but won’t start. Hint: Starter Problem or Low Battery 5 Key will not turn the ignition More
Why did Mercedes use a relay module instead of a block?
For some reason, Mercedes decided to use a complex and expensive relay module instead of a traditional block of separate relays. Normally if a relay fails, only that component will cease operation. In this case, the main power feed solder joint failed, cutting power from all accessories run by that module
What are the most common Mercedes Benz transmission problems?
Top 5 Mercedes-Benz Transmission Problems. Won’t come out of Park gear due to a defective brake light switch. ( DIY How to replace the Brake Light Switch) Continue to read if you would like to learn how to troubleshoot your Mercedes-Benz transmission yourself and where you should start. 1. Check Fluid Level
Why is my Mercedes K40 relay module not working?
Google to the rescue! Upon looking at a few articles online and checking out a few diagnostic websites, I concluded that it was likely a failure of the “K40 Relay Module.” *Remember to always disconnect the negative battery cable prior to any kind of electrical service.
What are the problems with the Mercedes C230?
The electrical connector at the automatic transmission may leak fluid. The mass air flow sensor can fail, resulting in poor fuel economy and Check Engine Light illumination. The CD changer may suffer from an internal mechanical problem.
Can you read the fault code on a Mercedes Benz?
Can read fault codes from multiple systems such as transmission, engine, ETS, airbag and more. Can clear fault codes. Can read and erase all fault codes on Mercedes-Benz cars. Only works on MB but can perform further troubleshooting including SBC brake systems, convertible systems, Air Conditioner (A/C) system. 3. Mercedes-Benz Star Diagnostic DAS
First, the customer complaint: car runs great, no problems, but it will occasionally die and fail to restart. About 15-20 minutes later, it will usually start and all is well until it does it again. Vehicle usually has to be driven 20 minutes or so before failure will occur.