What tools do I need to replace a CV axle?
Tools and Equipment Needed to Replace a CV Axle
- Breaker bar.
- Dead-blow hammer.
- Drain pan.
- Jack and jack stands.
- Large hammer or mallet.
- Long-handled diagonal cutting pliers.
- Pry bar or CV axle puller.
- Ratchet and socket set.
What all do you need to change a CV axle?
What Tools Do I Need to Change a CV Joint?
- Vehicle Jack. Removal of a CV joint requires that you jack the vehicle off the ground to allow access to remove the wheel and components from the wheel hub.
- Lug Wrench.
- 3/8″ Drive Socket Wrench Set.
- Tie Rod Puller.
- Hub Socket.
How hard is it to change a CV axle?
replacing both sides shouldn’t take any more than 4 hours. have your manual with you, you’d probably need to undo the cv lock nut, separate complete hub assembly from the strut, pull the cv out.
How do you tell if your CV axle is bad?
Below are the four most common symptoms of a bad CV axle; if you notice any of these, head to your local Chevrolet service center immediately.
- “Clicking” Noises When Turning.
- A Knocking Sound.
- Grease on the Inside or Edge of the Tires.
- Vibration While Driving.
Which is the best CV axle removal tool?
CV Axle Wedge and Popper Set, Fork and Shim Tool, Designed to fit The Most Common CV axles, transaxles and transmissions – 647749M . Only 12 left in stock – order soon.
How to replace an automotive CV axle-2carpros?
Reinstall the CV Axle Nut Reinstall the CV joint axle nut by hand to avoid cross threading and then tighten to manufactures specification with is usually between 120 and 140 foot pounds for torque. Install a new cotter pin and then bend one end if it over the axle threads to hold it in place while cutting off any excess and you are all set.
How are CV joint axles used in vehicles?
Some vehicles even employ CV joint axles in the drivelines. A CV joint is a collection of bearings and cages that allows for axle rotation and power delivery on a number of different angles and planes and enables the axle to change length as it travels up and down.
When do CV axles go out of stock?
CV Axle Wedge and Popper Set, Fork and Shim Tool, Designed to fit The Most Common CV axles, transaxles and transmissions – 647749M . Only 12 left in stock – order soon. . In stock on May 15, 2021.