What to do if rear running light is not working?
You will only get voltage/light on the R/Y when brake is applied. If you use a test light you can check your ground (Blk.) by hooking the alligator clip to your Battery + post then then light probe to the Blk. wire. If the Blk. wire is good then the light will light.Easy way to ck. grnd. connections.
Are there any wires under the rear fender?
It seemed ok, no rust or corrosion. I dident notice any breaks in the wire running under the rear fender. Under your seat there should be a 3 or 4 wire connector to the rear fender. It should have a 1 Black,1 Red/Yellow, 1 Blue wires. There may also be a Orange/White for HDI models. Use a Volt meter or a 12volt test light.
Why is the rear tail light not working?
neither the hand break lever or the foot lever are doing anything. The rear running light is not working either. I checked the connector at the rear tail light. It seemed ok, no rust or corrosion. I dident notice any breaks in the wire running under the rear fender. Under your seat there should be a 3 or 4 wire connector to the rear fender.
Where is the turn signal on a Harley Davidson?
I dident notice any breaks in the wire running under the rear fender. Under your seat there should be a 3 or 4 wire connector to the rear fender. It should have a 1 Black,1 Red/Yellow, 1 Blue wires. There may also be a Orange/White for HDI models. Use a Volt meter or a 12volt test light.
Why is my left turn signal not flashing?
When it’s not working, there is no signal front & rear and no signal indicator either. When working, both markers function properly as does the indicator. With new bulbs installed and sockets cleaned, I’ve narrowed the problem down to either the left turn signal switch or the turn signal module.
You will only get voltage/light on the R/Y when brake is applied. If you use a test light you can check your ground (Blk.) by hooking the alligator clip to your Battery + post then then light probe to the Blk. wire. If the Blk. wire is good then the light will light.Easy way to ck. grnd. connections.
It seemed ok, no rust or corrosion. I dident notice any breaks in the wire running under the rear fender. Under your seat there should be a 3 or 4 wire connector to the rear fender. It should have a 1 Black,1 Red/Yellow, 1 Blue wires. There may also be a Orange/White for HDI models. Use a Volt meter or a 12volt test light.
Why is my blinker not working on my Turn signal?
A direction signal system is designed to operate with a flasher or blinker unit which interrupts the signal which created the blinking action. Learn more – Locate turn signal flasher in Google Images. Step 4 – When a turn signal switch fails the system will short or go “open” causing the blinker not to operate.