What should torque settings be for front caliper bolts?
Oh yes, don’t get disheartened by Loub’s high torque settings. 115 Nm is 85 ft/lb, in other words the same as used for the wheels bolts. So you only have to set your torque wrench once and do both the caliper-to-knuckle bolts and the wheel bolts. Hey, Kobus.
How big are the front caliper slide bolts?
100 ft lbs for caliper slide bolts??? not unless you want to drill out the broken stud…..the torque spec are: Front caliper pins – 24 ft lbs and rears 11 ft lbs. Click to expand… Holy cow foo!
What are the torque specs for front brakes?
2002 SLK 32 AMG, bone stock. 1987 190E 2.3-16 valve (destroyed). 2005 E320 new toy. 85 ft lbs and 110 Nm are quite close, either works depending on how your torque wrench is calibrated, assuming it is in fact calibrated…..
How big is the caliper bolt on a Kia?
Thanks again, if im just removing pads and re-greasing i wont need to take the assembly bolt off will i? just the two bracket bolts, so the 24nm would be enough?, i do have a larger one for the wheel nuts but i doubt i could gt it into the rear arch. I stumbled across this earlier today, it could be handy.
What are torque specs for front brake caliper?
Torque specs for front brakes caliper mounting bracket bolts torque 85 ft lbs torque caliper bolts 26 ft lbs.. Drain brake fluid to ½ full level in reservoir. Remove the front wheels. Remove the front brake caliper assembly.
How much torque do you need for a brake bracket?
80 lbft on the bracket bolts and 37 on the sliding pin bolts. I will prob use a torque wrench for the bracket bolts. Usually when I open the sliding pin bolts to check brake pads I just snug them back by hand.
What’s the torque setting on a caliper carrier bolt?
These bolts (caliper carrier bolts) have fairly high torque setting, 115 Nm. Also MB wants you to use new bolts but many people just put thread locker back on the existing bolts.
How can I Fix my rear brake caliper?
Using a large C clamp or equivalent press the piston into the caliper. Coat both sides of the outer anti-squeal shim with pad grease. Install anti-squeal shims to each pad. Install wear indicators on the 2 brake pads. Install the caliper slide pin bushings (TMMK made) (Kentucky). Install the rear brake caliper with the slide pins.