What should be done before replacing a starter?
How to Replace a Starter
- Safety First. Disconnect the battery.
- Remove the Wiring. Remove the wiring and positive battery cable from the starter solenoid.
- Remove the Starter and Bolts. Remove the starter retaining bolts.
- Compare to Verify.
- Transfer Heat Shield.
- Replace with New Starter.
- Secure and Tighten.
- Connect the Wiring.
Where is the starter on a 94 4Runner?
Work from beneath the truck to locate the starter motor at the rear of the engine compartment near the bottom. Remove the nut securing the battery cable to the switch on the starter. Pull the cable off the switch and set the nut aside in a secure place.
Can you fix a starter without replacing it?
And frankly, most people will never need to replace a starter motor for the life of their vehicle. Usually, auto electric shops can rebuild or repair a starter with a bad armature, shorted field windings, bad brushes, a bad commutator, or even a bad solenoid if there is no alternative.
Where is the starter on a 2006 Toyota 4Runner?
Most Toyota 4Runners have the starter motor mounted to one side of the engine along the lower area, as most vehicles do. However, the Toyota 4Runner with the 2UZ-FE engine has the starter mounted on top between the two cylinder banks. To change the unit on this model, you will have to remove the intake manifold.
When to replace the starter on a Toyota 4Runner?
This article applies to the Toyota 4Runner V6 (1984-1995). If you hear a clicking sound when you turn the ignition on your truck, odds are the starter motor is bad. Sometimes you can hit the starter with a small hammer to get it working again, but this indicates that the starter motor needs replacement.
Where is the signal wire on a Toyota 4Runner?
The upper red arrow points at the starter motor and the lower red arrow points at the nut holding the positive cable. This is seen from the right wheel well. Next thing to do is to remove the signal wire from the starter motor. The signal wire is the wire that gives the impulse to the starter motor to start cranking the engine.
How do you set a new starter motor?
Set the new starter motor in place, making sure the teeth on the starter motor pinion gear and the teeth on the flywheel mesh perfectly-otherwise the starter motor will grind against the flywheel and damage the unit. Install the mounting nuts or bolts by hand first. Tighten the nuts or bolts to 29 foot-pounds (39 Nm).
Can you change the intake manifold on a Toyota 4Runner?
To change the unit on this model, you will have to remove the intake manifold. Keep in mind that this procedure applies to all 4Runners except the 2UZ-FE model. Park your Toyota 4Runner in safe place and level surface. Open the hood and disconnect the black, negative battery cable.