What kind of socket do I need for 4WD?
4543A-4 – 6-lug socket for removing and installing 4-slot front axle locknuts on 1978-84 Ford F-Series 4WD heavy-duty 3/4- and 1-ton trucks; 1973-81 GM 4WD 3/4- and 1-ton trucks.
What kind of wrench do I need for spindle nut?
Use with 1/2-Inch square drive tool. Wrench fits spindle nut on Chevy, 1/2-ton GMC, Blazer, Bronco, Bronco 11, Ranger, Explorer, 1/2- and 3/4-ton Ford, spline-type hub, IHC 1100 series and 1/2-ton Dodge vehicles. Will work on Ford vehicles with ratcheting type lock nuts on front axle..-Octagon Spindle Nut Wrench 3-7/8-Inch.
What kind of socket does a Toyota 4 lug use?
Chrome vanadium steel sockets cover most SUV and light truck applications. Sockets have 1/2″ square drive, allowing use of a torque wrench, ratchet, or breaker bar. 4543A-1 – Toyota 4-lug locknut socket.
How big are the spindle nuts on a trans?
The engine is 460, and trans is the 4OD, but that doesn’t matter. This socket does not fit the spindle nuts on my differential, despite being advertised as doing so. The nuts are maybe a 1/4 inch larger in diameter than the socket.
What kind of spindle nut wrench do you use?
Spindle Nut Wrench, Chromoly, 1/2 in. Drive, Chevy, Ford, Not for Use with Impact Wrenches or Power Tools Sockets, Spindle Nuts, Steel, 1/2 in. Drive, Set of 6 Spindle Nut Wrench, Chromoly, 1/2 in. Drive, Ford, Not for Use with Impact Wrenches or Power Tools, Each Axle Locknut Socket, Steel, Rear, Ford, 10.5 in. Rear, Each
4543A-4 – 6-lug socket for removing and installing 4-slot front axle locknuts on 1978-84 Ford F-Series 4WD heavy-duty 3/4- and 1-ton trucks; 1973-81 GM 4WD 3/4- and 1-ton trucks.
How many Ford spindle nut sockets are there?
Sold individually. (22) Sold as a set of 6. (2) Sold as a set. (1) Would You Like to Pick it up? Select your preferred location and we’ll note which parts are ready to be picked up TODAY. Sold individually. (22) Sold as a set of 6. (2) Sold as a set. (1) Select your preferred location and we’ll note which parts are ready to be picked up TODAY.
How does a 4 lug spindle nut work?
The lock ring is installed by indexing it on the first nut (may have to be flip over lock ring to find best fit) then the outer 4 lug nut is torqued to spec. 1) We torque the first nut down to 65 ft/lbs (to seat pre-greased bearings), then loosen and re-torque first nut to 35 ft/lbs while spinning wheel.