What is a swirl control valve?
While idling and during low engine speed operation, the swirl control valve closes. Thus the velocity of the air in the intake passage increases, promoting the vaporization of the fuel and producing a swirl in the combustion chamber. This solenoid valve is operated by the Engine Control Module (ECM).
What does swirl flaps do?
Swirl flaps produce a swirl alongside the cylinder axle. They are used in diesel vehicles to improve the mixing of the fuel-air mixture at low engine speeds. For this purpose, the air is fed to each cylinder through two separate channels in the intake manifold. Swirl flaps are also called “inlet duct cutoffs”.
What is tumble control valve?
Tumble control valve has a valve portion in the intake passage of each cylinder. While idling and during low engine coolant temperature, the tumble control valve closes. Thus the velocity of the air in the intake passage increases, promoting the vaporization of the fuel and producing a tumble in the combustion chamber.
When did the Nissan Sentra B15 come out?
In this article, we consider the fifth-generation Nissan Sentra (B15), produced from 2000 to 206. Here you will find fuse box diagrams of Nissan Sentra 2000, 2001, 2002, 2003, 2004, 2005 and 2006, get information about the location of the fuse panels inside the car, and learn about the assignment of each fuse (fuse layout) and relay.
Why does my Nissan Sentra Jerk when I start it?
MY car started jerking when i started it and while i was driving it when i push the gas it would not jerk as bad but it seemed like it did not want to pick up speed and when i stop it acts like it wants to die. HELP!! I have already had the timimg belt changed
Why does my Nissan Sentra feel like it swallowed a watermelon?
My Nissan Sentra 1.8 S started to feel like it swallowed a Watermelon. Very sluggish to drive and hard to start. This car has 82,000 miles on it and has been well maintained. Found out that there is a service campaign on the Fuel Pump.
Where is the fuse box on a Nissan Sentra?
Here you will find fuse box diagrams of Nissan Sentra 2000, 2001, 2002, 2003, 2004, 2005 and 2006, get information about the location of the fuse panels inside the car, and learn about the assignment of each fuse (fuse layout) and relay. Cigar lighter (power outlet) fuse in the Nissan Sentra is the fuse #22 in the Instrument panel fuse box.
When is the p1130 Toyota engine code detected?
Most auto repairs shops charge between $75 and $150 per hour. When is the P1130 TOYOTA code detected? The 1130 code is set when A/F sensor output voltage change value is not what the Engine Control Module (ECM) is expecting. The Air-Fuel ratio (A/F) sensor varies its output voltage in proportion to the air-fuel ratio.
What is the OBD II fault code p1130?
END OF SPECIAL NOTES. OBD II fault code P1130 is a manufacturer specific code that is defined by carmaker Toyota and by extension, Lexus, as “Air/Fuel Ratio Sensor Circuit Range/Performance Malfunction Bank 1 Sensor 1.
What does the 1130 code mean on a Toyota?
The 1130 code is set when A/F sensor output voltage change value is not what the Engine Control Module (ECM) is expecting. The Air-Fuel ratio (A/F) sensor varies its output voltage in proportion to the air-fuel ratio.
What causes a heater sensor to code p1130?
Some common causes of code P1130 could include the following-. Damaged, burnt, shorted, disconnected, or corroded wiring and/or connectors, especially on the sensor’s heater circuit. Defective heater circuit relay (where fitted)