What happens if you hook jumper cables?
What happens if you touch jumper cables together? When the jumper cables are hooked up to a battery, touching the cable ends together can create sparks. In some cases, the sparks can ignite the hydrogen gas escaping from the battery, causing an explosion.
Can jumper cables be hooked together?
Note that if your cables are too short to connect the two batteries, you can connect two sets of jumper cables to give yourself more length. Attach the other clip from the same cable to the positive terminal on the good battery.
When hooking jumper cables up what connection is connected last?
Safety Tip: You want to make sure that the last jumper connection made is the dead battery, not the live battery on the booster car. Visually check that jumper cables are connected securely to the battery. Also, double check that the cables aren’t dangling near any moving engine parts in either vehicle.
What happens if you connect the jumper cable backwards?
Car owners may accidentally connect the jumper cables in reverse order or install the battery backward, which causes the vehicle to no longer start. The purpose of this troubleshooting guide is to help answer the following questions: Hooked battery up backward now car won’t start.
Where is the diagnostic socket on a Toyota?
73 – Passenger belt pretensioner ignition (short circuit in the chain) The Toyota injection system up to 98 years has a diagnostic socket DLC1. Usually it is under the hood to the left and represents a box with the inscription “DIAGNOSIS”. This is the “mass”.
When does accumulation of codes occur in Toyota?
Accumulation of codes in this mode occurs when the contacts “E1” and “Te2” are closed before switching on the ignition. After that, the car should drive about 15 km. After stopping the engine does not muffle and at idle the contacts E1-Te1 are connected and codes are read out.
How to erase an error code on a Toyota?
If the codes are saved, you need to perform the cleaning procedure: – alternately, once per second, connect the terminals “TC” and “AB” (the pause between the closures is less than 0.2 seconds) – after the third closing of the output “TC” the indicator should blink at a high frequency – the codes are erased.