What drains a battery on a four wheeler?

What drains a battery on a four wheeler?

1. Bad or old battery – not holding a charge even when not connected to the ATV. All batteries will die at some point. If so, it’s more likely something on the ATV that is causing it to drain or causing it not to charge as it is supposed to.

Why does my Honda ATV battery keep dying?

When the battery in your Honda ATV keeps dying, the problem may not be the battery itself, but rather the machine’s charging system. If playback doesn’t begin shortly, try restarting your device.

Can a Honda TRX350 rancher battery be replaced?

This SigmasTek STX14-BS battery is a compatible replacement for the Honda TRX350 Rancher, 2000-2006 ATV battery. The battery in the Honda 350CC TRX350 Rancher, 2000-2006 ATV can be replaced with this durable, shock resistant powersports battery. It ships charged and ready to install in your ATV.

What should battery voltage be on Honda rancher 420?

A healthy, fully charged battery should read between 12.5 and 13 volts. If the reading is below 12.5 volts, charge the battery first and then if it doesn’t hold a charge higher than 12.5 volts, replace it.

Can You troubleshoot a Honda rancher no start?

Diagnosing electrical problems on a Honda ATV doesn’t take a great deal of mechanical prowess. In fact, most people can troubleshoot starting problems on their own with just a couple of simple diagnostic tools. Watch the video above and read on below to learn how to troubleshoot starting problems on a Honda Rancher TRX420.

Why does my ATV battery keep going dead?

This behavior is typical when you have an ATV battery that keeps going dead. But depending on what is causing your battery drainage, your bike may behave differently. It can lose all of its power in just a matter of hours.

How to start a Racher es with a dead battery?

To get it into neutral with a dead battery you will have to use the special tool that comes with it and do it manually there is a short post that sticks out on the front of the engine it connects to. However it is my understanding that if battery is dead and will not run the fuel pump if its a fuel injected model then the pull starter is worthless.

How can I tell if my ATV battery is fully charged?

Start by charging the battery. To perform this test you want to make sure the open circuit voltage available at the battery is above 12.4V (at least 75% charged). To check this you simply put your meter to DC voltage setting and connect the leads to the battery.