What causes noise in gearbox?
Noise. Bearing, gear and shaft wear are the most common causes of noise. As gear tooth faces and bearing races wear, they develop groves and small pits. While these are only small at first, they will gradually become larger, and as they grow, these imperfections will cause even more noise to occur.
Do you have a link for gear linkage adjustment?
Go on to the site and choose car S1, then upgrades/accersories, then engine. 42 quid and has a picture also I have searched the SJ site and can’t find this upgrade listed. Do you have a link?
Where is the gear linkage on a Honda Accord?
With everything in place there is one bolt on the Gear Linkage Joint which dictates the relationship between the front linkage (including the Gear Lever) and the rear linkage where it attaches to the gearbox.
Where is the gear linkage box on a VW?
The rear linkage rod and assembly will be completely disconnected and can be put aside. At the front of the vehicle above the spare wheel is the Gear Linkage Box. Undo the 10mm/13mm bolt here and the front linkage rod will come free, pull it forward and completely out. (You may have to remove the Gear Linkage Box as space is tight).
Where can I find a gear shifter bushing?
The bushing for the gear shifter lever can be found at most all auto parts stores. Do not shift the gear shifter in an aggressive manner to prevent looseness and slack within the gear shift. Fix a loose gear shifter lever as soon as possible to prevent the gear shifter lever from breaking in half.
What do I need to repair my gear linkage?
However, when inspecting the rods it was quite clear that all of the bellows would need replacing as they had perished as well as rust and wear on other parts. I opted for the Gear Linkage Repair Kit from Brickwerks, this includes not only new bellows but also the bushes, gear shift joint and selector cup.
The rear linkage rod and assembly will be completely disconnected and can be put aside. At the front of the vehicle above the spare wheel is the Gear Linkage Box. Undo the 10mm/13mm bolt here and the front linkage rod will come free, pull it forward and completely out. (You may have to remove the Gear Linkage Box as space is tight).
With everything in place there is one bolt on the Gear Linkage Joint which dictates the relationship between the front linkage (including the Gear Lever) and the rear linkage where it attaches to the gearbox.
Why is the gearshift locked on my HiAce?
Twice now when moving on with a cold engine the gearshift is locked and I can’t get any gears. If i turn the engine off and on again I can get neutral. I run the engine for a few minutes and then everything is OK, although changing is a bit chucky at first, then it’s OK for