What causes code P0345?
The P0345 is triggered when the powertrain control module (PCM) detects an inconsistent signal or lack of signal from the CMP sensor. The CMP sensor measures the exact rotational position and speed and position of the camshaft.
What can cause a camshaft position sensor code?
The most common causes behind the disruption of the signal from the camshaft position sensor to the PCM include: Failing or defective camshaft position sensor. Circuit problems (e.g., damaged wiring, loose connections) Errors in the powertrain control module (somewhat rare)
Where is the camshaft position sensor A circuit Bank 2?
Usually, the Camshaft Position Sensor is located on the valve cover, in this case, engine bank 2 cover. Look for oil, dirt and/or metal debris attached to its magnetic tip. Clean the sensor with extreme care and re-install it on the vehicle.
What is the camshaft position sensor bank 2?
The “Bank 2” in this definition refers to the side of the engine that does not contain the number one cylinder. Meanwhile, the “Sensor A” refers to the intake camshaft sensor.
Where is camshaft position sensor bank1?
Beneath the timing belt cover is where the CMP Sensor is mounted. The camshaft position sensor can be found in the right side of the engine compartment at the rear of the valve cover.
Can you drive a car with a bad camshaft position sensor?
Yes, it is safe to drive with a bad camshaft sensor. However, the performance of your engine will not be as good and fuel consumption may increase. In some cases, the camshaft may need replacement if there are any other symptoms of failure on this component.
What code is P0345?
What Does P0345 Mean? The camshaft position sensor located in the internal combustion engine monitors the position and rotational speed of the camshaft. When the trouble code P0345 is set, the ignition spark and fuel injector timing fail due to the engine not knowing when to fire these components.
What is code P0011?
What Does Code P0011 Mean? The variable valve timing system increases fuel economy and engine performance by regulating when the intake and exhaust valves are opened and closed. When trouble code P0011 is set, it means that the intake camshaft in Bank 1 is more advanced than the ECM has told it to be.
What to do if your camshaft position sensor says p0345?
Visually inspect the camshaft position sensor connector in search of corroded or broken connectors. Make any other repairs (if other codes are present) to make sure that other codes are not sources of the trouble code P0345. Check your camshaft position sensor’s voltage, ground, and signal readings with a multimeter.
What does the p0345 OBD-2 code mean?
The P0345 code indicates that the car’s computer has detected an incorrect voltage reading from the bank 2 camshaft position sensor. In order to ensure proper engine timing and correct fuel delivery for driving conditions, your car’s computer needs information about camshaft position and speed.
What is the DTC code for Camshaft Position Sensor?
P0345 is a diagnostic trouble code (DTC) for “Camshaft Position Sensor A Circuit Malfunction (Bank 2)”.