What are the connectors for Microsoft Power Query?
The following table contains a list of all the connectors currently available for Power Query. For those connectors that have a reference page in this document, a link is provided under the connector icon and name.
How to load data from power query online?
To load data from a web site with Power Query Online: From the Get Data dialog box, select either Web page or Web API. In most cases, you’ll want to select the Web page connector. For security reasons, you’ll need to use an on-premises data gateway with this connector.
Where are the OBD II data link connectors located?
This is great because OBD I vehicles have different proprietary connections that require several different types of connectors to tap into. OBD II connectors are located in the passenger’s compartment close to the steering wheel for easy access from the driver’s side, passenger side, or from outside the vehicle.
What does a checkmark on a connector mean?
For those connectors that have a reference page in this document, a link is provided under the connector icon and name. A checkmark indicates the connector is currently supported in the listed service; an X indicates that the connector is not currently supported in the listed service.
How to test datalink diagnostics 54-133 JustAnswer?
1. Turn the ignition OFF and disconnect the batteries. 2. Connect the meter leads of a digital multimeter set to read ohms to pins C and D of the 9-pin diagnostic connector and measure the resistance. 3. Reconnect the batteries after the test is completed. See Table 3for test results and possible causes.
How big is a 9 pin data link connector?
The trucks that were checked had measurements that were about 65 to 68 ohms on pins C and D of the 9 pin data link connector. In most data link troubleshooting text books this is an acceptable measurement and falls within the 60 ohms + or – 10 ohms.
When did the OBD II data link connector come out?
The DLC or Data Link Connector is an OBD II, 16 pin, standard connector used in all automobiles manufactured since 1996. In today’s vehicles, it’s in constant communication with the CAN, or Computer Area Network.
How to troubleshoot data link with a calculator?
J1939 Data Link Troubleshooting with a Calculator 1 Remove resistor 1 out of the harness and measure it, let’s say it measures 118 ohms 2 Remove resistor 2 out of the harness and measure it, let’s say it measures 119 ohms 3 Plug these resistances into your formula to know what the actual measurement at pins C and D should be.