What are the basic components of a pump house?
Structural engineering has existed since humans first started to construct their own structures. The foremost basic in structural engineering is the design of simple basic components and members of a Pump house viz., Slabs, Beams, Columns, Wall and Footings.
How is structural analysis and design of pump house performed?
The design of Pump House involves manual load calculations and the whole structure is analyzed by staad.pro. LSM limit state method is used in staad.pro analysis conforming to IS-code of practice.
What kind of work is being done on the pumphouse?
The construction programme usually calls for work on the pumphouse, screen chambers, intake and tunnels to be carried out simultaneously to meet commissioning dates, often in parallel with jetty works.
How tall is the pump house in MCC?
Pump house = 38.5m*9.04m mcc building = 38.5m*12.0m Pump house raft bottom level = +191.00m Pump house top level = +212.500m Grade of Concrete M30 for up to Pump Floor Level and M25 for above Pump Floor Level.
What kind of casing is used for split case pump?
Split case pump design is used for ease of maintenance of the rotating elements, which can be removed without disconnecting the suction or discharge piping. For standard waterworks design for potable systems, pump casing will be cast iron and impellers will be bronze. Base for pump and driver will be cast iron or fabricated steel.
When to add a pump station to a system?
Where a pump station is added to an existing installation, previous planning and design, which is based upon a total system hydraulic analysis should be consulted before the addition is designed. New or updated studies will determine station location and present and future demand requirements.
Where are pump stations located in a water distribution system?
1.3 PLANNING FACTORS. Main pumping stations which supply water to the distribution system will be located near the water treatment facility or a potable water storage facility and will pump directly into the piping system. These pump stations may be a part of these other structures.
What to do if there is no power to the air suspension pump?
If there is no power going to the air suspension compressor, check the air suspension fuse and relay. Here is a picture that shows no power to the air suspension pump. The next step would be to use a professional diagnostic scanner such as the iCarsoft MB II to check the fault codes for the Air Suspension Control Unit.