How to use OBD diagnostic tool, Honda motorcycles?
Connection to the ECM is MUCH easier and quicker, just press the Connect button, and the OBD Tool does the rest. No need to enter the frame number, model. 3. All sensor values are shown at the same time, on one screen. 4. Can be used on a dyno, also when the rear wheel is spinning. 5.
What are the advantages of a Honda diagnostic tool?
Advantages Honda Motorcycles diagnostic tool. 1. Very low price, affordable even for individuals and small repair shops. 2. Connection to the ECM is MUCH easier and quicker, just press the Connect button, and the OBD Tool does the rest. No need to enter the frame number, model. 3. All sensor values are shown at the same time, on one screen.
What kind of computer do I need to run Honda diagnostic tool?
The software runs on any version of Windows, you can run it on a hardware (laptop, netbook) of your choice. All variants, special editions and BOTH ABS and non-ABS models are supported, except where noted for the selected bike model/year.
Is there a faulty O2 sensor on a Honda CBR600?
Faulty O2 heating sensor (California only) – Engine is operating normally Damaged E2-PROM in ECM Engine running normally – Self-diagnosis not saved How to reset errors of Honda CBR600 Motorcycle? Switch on the start-stop button to the run position, the ignition switch is off. Next, short-circuit the diagnostic connector with a jumper.
How to reset errors of Honda CBR600 motorcycle?
How to reset errors of Honda CBR600 Motorcycle? Switch on the start-stop button to the run position, the ignition switch is off. Next, short-circuit the diagnostic connector with a jumper. We turn on the ignition switch. After turning on the ignition, remove the jumper.
Where does the fault code go on a Honda CBR XX?
The engine control module ( ECM ) will store the relevant fault code in its memory and this code can be read as follows using the self-diagnostic mode of the ECM. While the engine is running and the motorcycle is being used, the FI light will come on and stay on.
Connection to the ECM is MUCH easier and quicker, just press the Connect button, and the OBD Tool does the rest. No need to enter the frame number, model. 3. All sensor values are shown at the same time, on one screen. 4. Can be used on a dyno, also when the rear wheel is spinning. 5.