How to set ignition timing on Mazda B2600 Fixya?
Turn all electrical loads OFF. Warm up engine and run for three minutes at 2500 – 3000 rpm. Connect tachometer and timing light to engine (white check connector). Ground test connector (green: 1-pin) with a jumper wire. Check that idle speed is within specification.
Where is the timing mark on a B2600i?
Rotate distributor or CAS until timing marks are aligned. Tighten lock bolt. On B2200 (PFI) and B2600i, connect jumper wire between ground and Green test connector in right rear corner of engine compartment. See Fig. 2.
Is there a problem with my Mazda B2600?
Having problems with your Mazda B2600 ? Hello pketelho. The spec is 5 degrees beforetop dead center. Couple of other items to do before checking here. .
What should idle speed be on B2600i Miata?
Place transmission in Neutral (M/T) or Park (A/T). Ensure idle speed is correct. See IDLE SPEED under IDLE SPEED & MIXTURE. If timing is not within specification, loosen distributor or Crank Angle Sensor (CAS) lock bolt (Miata only). Rotate distributor or CAS until timing marks are aligned. Tighten lock bolt.
Turn all electrical loads OFF. Warm up engine and run for three minutes at 2500 – 3000 rpm. Connect tachometer and timing light to engine (white check connector). Ground test connector (green: 1-pin) with a jumper wire. Check that idle speed is within specification.
Rotate distributor or CAS until timing marks are aligned. Tighten lock bolt. On B2200 (PFI) and B2600i, connect jumper wire between ground and Green test connector in right rear corner of engine compartment. See Fig. 2.
Place transmission in Neutral (M/T) or Park (A/T). Ensure idle speed is correct. See IDLE SPEED under IDLE SPEED & MIXTURE. If timing is not within specification, loosen distributor or Crank Angle Sensor (CAS) lock bolt (Miata only). Rotate distributor or CAS until timing marks are aligned. Tighten lock bolt.
Having problems with your Mazda B2600 ? Hello pketelho. The spec is 5 degrees beforetop dead center. Couple of other items to do before checking here. .