How to reset e brake module on Jaguar S-type?

Your problem may be due to low battery voltage, faulty park brake motor, module or possibly broken or binding parking brake cables. What you can do is reset the system. DIsconnect the negative battery cable for 10 minutes. Then reconnect it and start the engine. It will say “Apply park brake” on the messgae center.

Why is my parking brake not working on my Jaguar?

This code will need to be read with a Jag scan tool. Your problem may be due to low battery voltage, faulty park brake motor, module or possibly broken or binding parking brake cables. What you can do is reset the system.

Are there any problems with the jaguar’s type?

Seems to be a common fault on S type and apparently 05 was the worst year of manufacture for the amount of faults parkbrake issues being one I bought my car second hand and have had the intermitent parkbrake problem for more than a year …..

Can a Jaguar S-type thown go on the highway?

Crusing home on the highway going about 70MPH, not accelerating nor coasting, just maintaining speed. The engine basically shut down, and I had to pull onto the shoulder, it was very dangerous and frankly, it freaked me out.

How to calibrate a jagrepair EPB motor?

To do this, set the system into ‘Calibration Mode’ by doing a battery reset. Then, with ignition ‘ON’ and the vehicle brakes at room temperature, lightly press the brake pedal and apply the parking brake. Date of issue 12/05 Bulletin Number XJ206-07 Page 3 of 10 DTC C1784 – EPB MOTOR OUTPUT SHORT TO GROUND.

Can a fault be detected while the EPB motor is running?

This fault can only be detected while the EPB motor is running. If the fault is intermittent, try flexing any accessible wiring while the parking brake is being applied or released. To trace an EPB motor open circuit, carry out the following process: Note:Intermittent wiring faults may exist.

What to do when the parking brake is released?

Warning:Ensure the vehicle cannot roll away when the parking brake is released. Chock the road wheels, and on automatic vehicles ensure the gear selector is in park. 4. Apply and release the parking brake five times using the apply/release switch. 5. Recheck the failure memory for DTCs. DTCs that return are permanent faults.

Do you need to uncouple secondary parking brake cables?

When replacing the EPB actuator, do NOT replace the secondary parking brake cables unless they are worn or damaged. The actuator primary cable should be uncoupled at the compensator. There is no need to uncouple the secondary cables. Unnecessary uncoupling can damage the cable retaining lugs. 3.

What to do when the parkbrake doesn’t work?

Turn off the lights etc. Run the engine for five minutes to charge the battery a little. Switch off the ignition until every warning light goes out. Turn on the ignition again. The parkbrake then works normally, and the warning has gone. 9 people found this helpful. Worked for me.

How do you change the parking brake on a Jaguar?

To recalibrate it disconnect your battery and leave for 10 Min’s. then reconnect and with the ignition on apply the foot brake and whilst keeping applied switch the parking brake on. then release the foot brake turn ignition off – on and the handbrake fault message should be gone and the parking brake should release as you drive off.

How to change the parking lamp in a 2002 Jaguar S-type?

The AA disconnected the battery without sucess – but not for 10 minutes. Perhaps that would have solved it. The car had to be recovered to a dealer – its too clever for its own good! You can’t post conmments that contain an email address. How do you change the parking lamp in a 2002 jaguar s-type?

Why is the parkbrake stuck on my 2005 Jaguar?

Mine is a 2005 S Type sports automatic. I’ve had the warning message, and the parkbrake stuck on, five times, due to a low battery in cold weather. The first time, a Jaguar agent reset it by fiddling about in the boot for less than a minute. The next four times, (including today) I fixed it myself as follows.

What should I do if my jaguar’s type battery is low?

As an S-Type owner, you’ll be aware (I guess) of how sensitive the electronics is to low battery voltage. You’ll maybe not know though, what you’re expected to do after dis-connecting and re-connecting the battery.

How long does it take to reset a Jaguar battery?

Allow the vehicle to idle for a further three minutes. Drive the vehicle at constant speeds of approximately 48 km/h (30 mph), 64 km/h (40 mph), 80 km/h (50 mph), 96 km/h (60 mph) and 112 km/h (70 mph) for three minutes each. This may cause a driveability concern if the procedure is not carried out.

I thought it might be good to have a thread where we can list known Jaguar S-Type problems…

Can a parking brake be removed from a Jaguar?

Drove until first stop and then park brake locked on and Selector stuck in P. Jaguar Assist called and passed to AA. Selector sorted by lifting and moving lock located to left of gear stick. Brake still locked on. Battery removal no go. Removed the two plugs from Park Brake module (right hand side boot level with fuel filler.

What do you mean by parking brake fault?

Do you mean ‘parking brake fault’ This message can sometimes appear with low battery causing the electronic park brake to lose its calibration.

What to do if your parking brake does not come on?

Put the automatic gearbox in “parking” and push the parkbrake button down (i.e. to ensure it does not come on). Keep it pushed down and take the ingnition keys out of the it will not start the parkbrake motor. Whe you next get in the car, you will not see the “Park” light come on meaning the parkbrake is not on.

Where is the parking brake warning light on my Jaguar?

The dreaded Parking brake warning light came up on the dash a couple of days ago. I have tried re-set procedure (disconnect battery etc.) to no avail. I am reasonably handy with a multimeter and was wondering if anyone has a procedure for testing the centre console operating switch, to try and eliminate one part of the system.

Is there a problem with the park brake on a JAG?

I have Jag xf 09 2.7 d luxury. When starting park brake fault comes up with the wording unable to use park brake. Took it to garage they have had a look and said a load of codes have come up and it will be a process of elimination which will probably become quite expensive. Any one else had this problem or know what to look for.

What should I do if my Jaguar handbrake is not calibrated?

Disconnect the battery for 30 seconds. Reconnect the battery. 2. Start the engine. 3. Firmly apply and release the foot brake five times. 4. Confirm that the message “NOT CALIBRATED” or “APPLY FOOT AND PARK BRAKE ” is displayed on the instrument cluster message centre. This indicates that the parking brake is in calibration mode. 5.

Can a JAG XF 09 have a park brake fault?

Hi has anyone any ideas. I have Jag xf 09 2.7 d luxury. When starting park brake fault comes up with the wording unable to use park brake. Took it to garage they have had a look and said a load of codes have come up and it will be a process of elimination which will probably become quite expensive.

Is the park brake still working despite a warning message?

Daniel. Is the park brake still working despite the warning message, or is it permanently released or permanently on? There are a number of problems with the XF’s Electronic Park Release reported if you Google it.

Why does the parking brake not disengage on a 2005 Jaguar?

Re: parking brake will not disengage on 2005 jaguar s… Although a temporary workaround, disconnecting the battery and/or control module to release the park does not resolve why it became locked-on in the first place. The problem with many many S-types has been a failure of the park brake motor.

How to reset the battery in a Jaguar?

8 Release the foot brake. 9 Confirm that the brake warning lamp is no longer illuminated on the instrument pack and that “NOT CALIBRATED” message is no longer displayed in the message centre. 10 apply and release the EPB 5 times to ensure no error is present.

How can I reset the fuel economy on my Jaguar?

The distance, average speed and average fuel economy values for trip A and trip B can be reset. Set the Trip computer display to show the trip that you wish to reset, then press and hold the TRIP button until the message resetting trip is displayed.

How do you reset the trip memory on a Jaguar?

Set the Trip computer display to show the trip that you wish to reset, then press and hold the TRIP button until the message resetting trip is displayed. It is not possible to manually reset the Auto trip memory. This resets automatically each time the ignition is switched on. Trips may be added together, or removed to record a continuous journey.

When to reset the clock on a Jaguar?

Refer to the audio systems handbook or touch-screen display handbook. • If the battery is disconnected for more than 72 hours the radio preset channels will need to be reset. • Reset the clock to the correct time.

How to reset the ecu-1 Jaguar car forum?

Restart the clock (where fitted) and set it to the correct time. Simultaneously press “>>” “PTY” “A.MEM” should only take 2 or 3 seconds and the radio turns on. 1. NOTE: After the battery has been disconnected it is necessary to

Is the parking brake on a 2005 Jaguar?

Jaguar S-Type: My parking brake on 2005 Jaguar is locked on. My parking brake on 2005… My parking brake on 2005 Jaguar is locked on. “Parking brake fault” message on.

Is there a recall on the Jaguar S-type?

Make / Models : Model/Build Years: NHTSA CAMPAIGN ID Number : 04V488000 Recall Date : SEP 17, 2004 On certain passenger vehicles, the electronic park brake module, which controls the application of the parking brake, may unintentionally apply the parking brake without any indication or warning to the driver.

How to reset battery in jaguar’s type club?

Operate the window control switch until the door window glass is in the fully closed position, continue to operate the window control switch for a further two seconds. 2. Release the window control switch. 3. Operate the window control switch in the closed position and continue to operate the window control switch for a further two seconds. 4.

Is the Jaguar S-type repair information resource available?

No part of this publication may be reproduced, stored in a retrieval system or transmitted, in any form: e lectronic, mechanical, including photocopying, recording or other means without prior written permission from the Service Division of Jaguar Cars Limited. DATE OF ISSUE: May 20041

How to calibrate the EPB on a Jaguar?

Still the same problem, locked in park and trying to calibrate the EPB mode but failing with the Cannot Engage Parking Break message. I tried the calibration method several times (pump the foot brake 5 times then hold down the foot brake lightly, apply the parking break, release the parking break and then the foot brake) which didn’t help.

Where are the EPB plugs on a Jaguar?

No 2:- First on the right hand panel in the boot you will find two black plugs one on the right one on the back panel near the light cluster,undo these by unscrewing them.

How do you reset the EPB on a Jaguar?

This indicates that the parking brake is in calibration mode. 5. Lightly press the footbrake pedal. 6. Apply the parking brake by using the EPB switch. 7. Release the parking brake. 8. Release the footbrake.

Do you need to change the rear pads on a Jaguar?

For those who want to change the rear pads Jaguar recommend that the EPB (hand brake) is calibrated as detailed below. procedure in this bulletin. Failure to do this may result in incorrect operation of the Park brake, with warning lamps

How to release the park brake on a Jaguar?

I pulled the cover around the auto selector (remove ash tray and gently prize up with your fingers from the edge nearest the radio) and twisted the small plastic dowel 90 degrees (on the left side of the selector mounting). This released it from Park so I could get home.

Why did my Jaguar lose the EPB release?

Called Jaguar Assistance, as I have extended warranty. Technician said it was because battery voltage was <12.5v when switching on (before starting). He downloaded a software patch, said it won’t happen again.

No 2:- First on the right hand panel in the boot you will find two black plugs one on the right one on the back panel near the light cluster,undo these by unscrewing them.

Navigation