How to remove generator drive belt in Mazda 3?
2. Insert a wrench onto the cast hexagon on the drive belt auto tensioner and release the tension by slowly turning in the direction shown in the figure. 3. Remove the generator drive belt. 4. Install the generator drive belt. 5. Rotate the crankshaft pulley clockwise approx. halfway and verify that the generator drive belt is installed correctly.
When to replace drive belt on Mazda Demio?
The drive belt should be replaced every 100,000 Km or whenever showing many cracks on its grooves’ edges. Use a size 14 combination wrench on the belt tensioner bolt and pull firmly clockwise to make the latter tilt which releases the tension on the belt and allows you to take it out.
How to remove the drive belt on a Mazda CX-5?
Install the splash shield.. 1. Remove the generator drive belt.. 2. Apply a clean cloth to the water pump drive belt as shown in the figure. 3. Pull the cloth in the direction of the arrow and rotate the crankshaft pulley clockwise.
How often do you replace the serpentine belt on a Mazda?
Reinstall the access panel cover. Reinstall the wheel and lower the vehicle. Mazda recommends that the serpentine belt is replaced every 35,000 miles. The serpentine belt may also be referred to as the drive belt, accessory belt, or the alternator/air conditioner belt.
How do you replace the engine belt on a Mazda 3?
Step 1 Open the Mazda 3’s hood and support it with the prop rod. Connect the belt-tensioner tool into serpentine belt tensioner and move the tensioner pulley away from the belt with the tool. Pull the belt off the engine accessory pulleys by hand. Stretch one end of the old and new belts from the ground upward with your hand.
How do you remove a belt from an alternator?
Use a 14mm socket to push the tensioner away from the belt by turning it clockwise. You will need to use a cheater bar to move the tensioner back. Remove the belt from the accessory pulleys by hand. The belt will need to come off several pulleys including, an A/C pulley, alternator pulley, and power steering pump pulley.
How do you take drive belt out of Mazda Demio?
Use a size 14 combination wrench on the belt tensioner bolt and pull firmly clockwise to make the latter tilt which releases the tension on the belt and allows you to take it out. The action on the tensioner requires some force, do not hesitate to extend the wrench handle with any tube.
Where is the serpentine belt tensioner on a Mazda?
Park your Mazda on level ground. Engage the parking brakes. Open the hood of your Mazda. Locate the serpentine belt tensioner on your Mazda engine. You will need to move the tensioner away to release pressure from the belt.