How often should I grease my prop shaft?
A good guideline to start with is to grease your shaft every oil change. If you go wheeling and drive through a lot of dirt or water, grease your shaft as soon as you get home.
Should you grease driveshaft splines?
Grease fittings should be cleaned prior to application and trunnion faces flushed to remove contaminants. The grease used most often for driveline u-joint, splines, yokes and hanger bearings is capable of withstanding extreme pressure (either NLGI 1 or 2 grade), with a base oil viscosity of 460 centistokes.
What does NLGI 2 mean?
NLGI Grades 1-3 The most commonly used greases, such as those used in automotive bearings, would use a lubricant that is NLGI grade 2, which has the stiffness of peanut butter. Grades within this range can operate in a higher temperature range and at higher speeds than NLGI grades 000-0.
How often should you grease U joints?
every 5,000 miles
In most cases, you have to grease your u-joints every 5,000 miles or so. When you fail to service your u-joints on a regular basis, they will fail.
How Loose Should a boat prop be?
How Tight Should a Boat Prop Be? When you go to tighten the boat prop nut, you want to make it tight, but not crazy tight. A general rule of thumb is to tighten it by hand and add a 1/4 turn extra.
What is a ZERK?
Grease fittings, also known as zerk fittings or grease nipples, serve as lubrication points on bearing housings or other mechanical components. Their design provides a secure connection to a grease gun coupler for delivering precise amounts of grease into bearings and other moving systems.
What is Moly grease?
Moly grease is a special formulation that is used in situations where metal slides against mental under high pressure and is generally used on pinion gears and splines. This silvery black solid compound, which naturally occurs as the mineral molybdenite, is classified as a metal dichalcogenide.
Do you need to lubricate the propeller shaft on a 4Runner?
Propeller shaft lubrication is a very simple maintenance procedure to do, but it is often avoided because cleaning the grease off between the spider joints can be a bit tedious. Keeping the propeller shafts properly lubed will ensure the longevity of a critical component in your 4Runner.
Do You Grease the shaft when changing a propeller?
Greasing the Shaft – YouTube When changing a propeller, you should always grease the propshaft. Watch this short video for instructions. Find and purchase here:http://www.iboats.com/Quic…
What are the propellers on a 5th Gen 4Runner?
For the 4X4 5th Gen 4Runner driveline, there are two propeller shafts; for reference, these two shafts will be referred to as FWD (forward) and AFT propeller shafts in this write up. Each prop shaft consists of 2 spider joints and a slip yoke. In total there are six zerk fittings that will require greasing.
What kind of grease does a Toyota 4Runner use?
Toyota recommends two types of grease for the spider joint and slip yoke: Spider Joint: Lithium base chassis grease, NLGI No. 2 Slip Yoke: Molybdenum-disulfide lithium base chassis grease, NLGI No. 2 or Lithium base chassis grease, NLGI No. 2