How much is a water pump for a 1995 Toyota Camry?
The average cost for a Toyota Camry water pump replacement is between $319 and $366. Labor costs are estimated between $182 and $229 while parts are priced at $137.
Is it easy to replace a water pump?
While removing the pump is not difficult, you must have experience removing and replacing timing belts and their various components. It takes just as much work to get down to the timing belt as it does the water pump, therefore you should plan on replacing the belt at the same time.
How does it cost to replace a water pump?
The average water pump replacement cost is $550, with prices ranging from $461 to $638 in the US in 2020. But typically depends on the type of vehicle you drive and the auto repair shop you take it to. Labor costs are between $256 and $324 while parts cost between $205 and $314.
How long does it take to change the timing belt and water pump?
1-3 hours
Changing a timing belt and water pump can take anywhere from 1-3 hours depending on your skill level, so make sure you have the time and space to complete the job. Do the following before you start: Jack up the front of the car so you can access the undercarriage beneath the engine.
How do you remove a water pump from a Toyota Camry?
Remove the water pump pulley by wedging a pry bar behind the pulley and removing the four 12mm bolts. Remove the four 10mm bolts and two nuts that hold the water pump fastener in place. Spray down the area with brake cleaner. Place a drain pan underneath and remove the water pump with a pry bar.
When to replace timing belt and water pump on Toyota Camry?
Save yourself a bundle by doing some general maintenance on your Camry’s engine yourself. This article applies to the Toyota Camry (1997-2011). Many Camry owners dread the 60,000 mile marker because of the costly timing belt and water pump recommended maintenance interval.
Where is the drain plug on a Toyota Camry?
Remove the drain plug from the bottom of the radiator on the passenger side. Replace the plug when finished. You will also want to drain it from the engine block as well by removing the two drain plugs on the bottom front and rear of the engine. The rear is a little more difficult to get to.
How can I tell when my water pump needs to be replaced?
Find the round part at the front of your water pump that the belt is around. Attempt to rock the pulley back and forth. If it seems to be loose, it may be time to replace it, because the bearing is going bad.