How much does it cost to replace shocks and struts on a 2002 Toyota Avalon?
The average cost for a Toyota Avalon suspension shock or strut replacement is between $604 and $663. Labor costs are estimated between $226 and $285 while parts are priced at $378.
How do you take the back seat out of a 2002 Toyota Avalon?
How to Remove the Rear Seat of a Toyota Avalon
- Open the driver- and passenger-side doors and slide the front seats forward.
- Lift up the forward edge of the bottom seat cushion.
- Remove the bottom seat cushion and carefully pull it from the Avalon.
- Locate the seat back’s four mounting bolts and remove them.
Does Toyota Avalon have folding rear seats?
This Toyota doesn’t have as much cargo space as some class rivals, but putting the Avalon’s 60/40-split-folding rear seats down expands the cargo area and gives you the flexibility to stow larger items.
How to replace front shock and strut on Toyota Avalon?
Front Shock and Strut Replacement. First, find a level piece of ground to park the Avalon on. Then, engage the parking brake. Next, remove the front tires and jack the front end into the air with support from jack stands. The front assemblies for the Avalon are under the front of the car.
What should I do to my Toyota Avalon?
Disconnect the negative battery cable and rear seat cushions. You will also need to raise the rear of the Avalon with support from jack stands. Also, remove the rear wheels. Next, disconnect brackets and sensors from the strut and stabilizer bar link nut.
Where are the front assemblies on a Toyota Avalon?
The front assemblies for the Avalon are under the front of the car. You can locate them by looking for springs with hardware that runs through the assembly and connects to the end of the suspension. Find the wheel hubs and the brake hose that is connected to the strut. Disconnect the anti-lock brake sense and mounting bracket.
How to replace Shock and strut on Toyota Camry?
Make sure to torque the center nut to 36-foot lb. It is time to re-install the strut and you will start to do this by putting the strut to the frame. Install the upper mounting nuts and torque them to 29-foot lbs. Next, hand tighten the strut to the arm. Connect the link nut to the strut and replace any brackets or sensors.