How much does it cost to replace an axle on a Jeep?
The average cost for a Jeep Wrangler axle shaft replacement is between $945 and $1,001. Labor costs are estimated between $186 and $234 while parts are priced between $759 and $767.
When do you need to replace the front axle on a Jeep Grand Cherokee?
The axle has two joints, called CV joints, that flex and allow the axle mobility when turning and going over bumps in the road. When the axle fails, it is usually because of CV joint failure. This often presents itself as a clicking or grinding noise when you make turns. When this happens, you must replace your Grand Cherokee’s front axle.
How to install a Jeep Wrangler front axle U-joint?
With the U Joint out you can now put the new U joint in. Remove the caps very carefully as to not move any needles inside the cap. I put a small amount of grease in the axle ear holes to help get the caps back on. Finagle the joint in between the Axle ears, then carefully put the caps back on, again make sure none of the needles moved.
Can you remove the hub from a Jeep Wrangler?
Now you can remove the whole hub, just give it a couple taps from behind with a hammer and it comes right off. With the Hub off you can now pull out the axle shaft in order to change the U Joint. The shaft just slides out. Be careful when getting the U joint out to not damage the splines on the shafts.
What’s the best way to install a front axle?
The easiest way to do that is with a press. If a press isn’t available there are plenty of trail tricks and other methods to get the joint out but we recommend a press, as it is the safest and least damaging to other parts.
With the U Joint out you can now put the new U joint in. Remove the caps very carefully as to not move any needles inside the cap. I put a small amount of grease in the axle ear holes to help get the caps back on. Finagle the joint in between the Axle ears, then carefully put the caps back on, again make sure none of the needles moved.
Now you can remove the whole hub, just give it a couple taps from behind with a hammer and it comes right off. With the Hub off you can now pull out the axle shaft in order to change the U Joint. The shaft just slides out. Be careful when getting the U joint out to not damage the splines on the shafts.
The easiest way to do that is with a press. If a press isn’t available there are plenty of trail tricks and other methods to get the joint out but we recommend a press, as it is the safest and least damaging to other parts.
Can you change the U joint with the hub off?
With the Hub off you can now pull out the axle shaft in order to change the U Joint. The shaft just slides out. Be careful when getting the U joint out to not damage the splines on the shafts. There are clips on each ear of the U Joint that hold the Joint in place.