How much does it cost to replace a catalytic converter on a Toyota RAV4?

How much does it cost to replace a catalytic converter on a Toyota RAV4?

The average cost for a Toyota RAV4 catalytic converter replacement is between $1,321 and $1,374. Labor costs are estimated between $160 and $202 while parts are priced between $1,161 and $1,171.

Does Toyota RAV4 have a catalytic converter?

Toyota Rav4s have two catalytic converters. The front one is bolted directly to the manifold in the front of the exhaust system and the second one bolts directly to that. In most cases, the converter that fails will be the rear converter.

Does a 2012 Toyota RAV4 have a catalytic converter?

Notes: Rear, Exhaust manifold with integrated catalytic converter. Legal for use in the state of California, New York and Maine.

What happens when you replace a RAV4 catalytic converter?

Ensure that you’re always able to rely on your vehicle when you replace your catalytic converter for Toyota RAV4. When this part malfunctions, you often experience a latent reduction in engine performance. This means that when you first hit the gas, it feels like no fuel reaches your engine.

What causes a Toyota RAV4 exhaust pipe to fail?

In most cases, the converter that fails will be the rear converter. Converters fail after a while clogging, breaking down internally (which is a result of clogging and overheating), and have inlet or outlet pipes that crack or leak exhaust. Having to replace them requires experience. Put the Toyota Rav4 on a car lift and bring all the way up.

Where do you cut the converter on a RAV4?

Light the torch and cut the two or three bolts (some of the rear converters have a three-bolt inlet and some have two of the Rav4s) out of the rear flange. Cut them from the front converter side so you do not incur any damage to the rear converter.

How can I Check my RAV4 for leaks?

Remove the cart and tools and any debris on the floor, lower the Rav4, and start it up to check for any possible exhaust leaks. With the Rav4 raised on a lift, locate the oxygen sensor bolted to the rear converter. Follow the wire to the plug and separate it by unplugging it. You may need the screwdriver to press in the clip lock.