How long does it take to replace drive belt on Harley Davidson?
Part 2 of the Harley Davidson drive belt replacement and removal. This is the longest procedure we have done to date. The belt removal and replacement videos are over 2 hours and 48 minutes.
When is a drive belt should be replaced in your car?
Most cars have one or two drive belts. When a car has only one drive belt, it might be called a serpentine belt. For example, this Ford engine in the first photo has only one drive or ‘serpentine’ belt. The car in the next photo has two drive belts.
Are there any Harley Davidson belt drives left in stock?
Only 3 left in stock – order soon. . Only 1 left in stock – order soon. . Belt Drives LTD. Kevlar Clutch Kit for Harley Davidson 1941-E84 Big Twin Models . . Only 12 left in stock – order soon. . In stock on May 2, 2021. . Only 2 left in stock – order soon.
What happens if your serpentine belt breaks in your car?
Eventually, an extremely-worn serpentine belt will break. If a drive belt breaks, you won’t be able to drive your car. This is because the engine will overheat if the water pump is not running. Also, if your car has hydraulic power steering, you will lose the steering assist, as the power steering pump will be disabled.
What should the belt deflection be on a Harley Davidson?
With sprockets rotated to tightest belt posi-tion, belt deflection “B” (measured at position “A”) should be 5/16-3/8 in. 1. Loosen rear axle nuts. 2. Measure each side from the flat to the end of the swingarm, to be sure rear axle is correctly located. 3. Turn axle adjuster nuts (metric) on each side of swing-arm to adjust belt deflection. a.
When to make a rear belt drive adjustment?
The adjustments should be done when the bike is cold. The adjustments should be made with the weight of a rider on the bike. 1. At the lower strand, position “A”, mid-way between transmission sprocket and rear wheel sprocket, apply 10 Ibs. of upward force on lower span of rear belt.
How do you adjust belt deflection on a car?
2. Measure each side from the flat to the end of the swingarm, to be sure rear axle is correctly located. 3. Turn axle adjuster nuts (metric) on each side of swing-arm to adjust belt deflection. a. Turn clockwise to decrease deflection (increase tension). b. Turn counterclockwise to increase belt deflection (decrease tension).
Part 2 of the Harley Davidson drive belt replacement and removal. This is the longest procedure we have done to date. The belt removal and replacement videos are over 2 hours and 48 minutes.
How do you remove a pulley belt from a car?
With the tension relieved from the belt, pull it off of the pulley that has been placing tension on it, then remove it from the around the rest of the pulleys on the engine. If the belt is severely damaged, be sure to remove any parts that may have come off of it as well. Compare the new belt to the old one.
Where can I get a drive belt replacement?
The most popular service booked by readers of this article is Serpentine/Drive Belt Replacement. YourMechanic’s technicians bring the dealership to you by performing this job at your home or office 7-days a week between 7AM-9PM. We currently cover over 2,000 cities and have 100k+ 5-star reviews…
How do you tighten a serpentine belt on a car?
If your vehicle does not have an auto tensioner, insert a pry bar or piece of wood between the alternator and the engine. Run the belt over the alternator pulley, then use the bar to pry the alternator away from the engine and increase the tension on the belt. Tighten the bolts again as you apply tension.