How do you wire an aftermarket fog light?
- Installing Wiring For Your New Fog Lights.
- Locate Your Vehicle’s Pass Through Hole In The Firewall Designed For Wires To.
- Connect Your Fog Light Switch.
- Synch Power For The Fog Lights To Your Ignition.
- Removing A Bumper Cover To Install Fog Lights.
- Cutting Holes In Your Bumper Cover To Mount New Fog Lights.
What is needed to wire fog lights?
Use a short piece of 18-gauge wire with a solderless female spade connector on one end, and a solderless ring terminal on the other. Place the relay mounting screw through the ring terminal before mounting the relay to the body to ground the relay. Connect the spade connector to terminal 87 on the relay.
How much is fog light installation?
On average, installing new fog lights with a professional mechanic will cost anywhere from $150 to as much as $450. On a forum thread at PILOTEERS.org, forum members indicated that fog light installation could cost around $180 to $255.
How to install your fog light wiring to factory switch?
Found this article for installing your harness for fog lights to your fuse block and shows were D6 is on the block. This only if you don’t have a harness and have to add it.
What kind of fog lights do I Need?
Bumper mount lights fit in specifically designed holes and are usually round or rectangular. This style is the way that most fog lights come from the factory. If you’re replacing your stock fog lights, this is where to start. Grill Mount. Larger, usually round.
Where are the fog lights on a car?
Bumper mounted fog lights are typically below the headlights. Check your vehicle manual if you have difficulty locating them. Disconnect the fog light switch from the housing. This disconnects the fog light from the vehicle’s power system. It should disconnect by detaching the clip. Remove the washer, bolt, and nut.
Where can I get a relay for my fog light?
Relay- you can get at any part store or on ebay. First disconnect your battery and remove the brace above the fuse panel. Then remove the cover and add the relay, look under the cover it will show the place for the relay.