How do you turn off the tire pressure light on a Mini Cooper?
Locate the reset button positioned in front cabin on the emergency brake handle. Turn the ignition to position 2, press and hold the reset button until the yellow indicator on the dash lights up for a few seconds. The vehicle is now ready to recalibrate the TPS system on your next drive.
What does the tire pressure warning light mean?
What Does the Tire Pressure Warning Light Mean? The tire pressure light warns you when one or more of your tires is low on pressure and needs to be set to the correct PSI. Is it safe to drive with the tire pressure warning light on?
What does it mean when your TPMS warning light is on?
So check your tires carefully. If your vehicle has a TPMS, it’s probably monitoring the pressure in your spare tire. Therefore, if you get a low tire pressure warning light, and if you’ve checked all four tires that are touching the ground, than you might need to put some air in the spare.
When does the low tire pressure light turn off?
The low tire pressure light, also know as the TPMS system, on your car should turn off when you have filled your tires to the proper pressure, or “PSI.” Sometimes, it just doesn’t work though.
How can I Reset my tire warning light?
Instructions for how to reset your tire warning light vary from model to model. Consult your owner’s manual to find the exact steps. Remember – under-inflated tires wear out more quickly, are less fuel-efficient, and more likely to cause an accident. Your TPMS is helping to make you safer, but it can’t do all the work.
What does a flashing tire warning light mean?
If your tire pressure warning light is blinking, it could mean that the weather is causing your tire pressure to fluctuate, triggering your sensor on and off. While this is typically not an emergency, it could indicate that your tire pressure is getting low and should be checked by your local BMW mechanic.
How do I get my low tire pressure warning light to turn off?
Turn the ignition key to “ON”. If the low tire pressure warning light comes on, push the reset switch for a few seconds and make sure the warning light goes off. Push and hold the reset switch until the low tire pressure warning light blinks three times.
What to do when the tire pressure light is flashing?
For most cars, all you need to do are the following: Put your vehicle key in the ignition to turn the battery on. Push the TPMS reset button until you see a flashing tire pressure light, which usually appears after approximately three seconds. Start your vehicle. Drive for about 20 to 25 minutes. Turn your car’s ignition off.
How do you reset tire monitor light?
Hold the TPMS reset button until the tire pressure light blinks three times, then release it. Start the car and wait 20 minutes for the sensor to refresh. The tire pressure monitor reset button is usually located beneath the steering wheel.